会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 3. 发明授权
    • Control device for vehicle
    • 车辆控制装置
    • US09180886B2
    • 2015-11-10
    • US14382040
    • 2012-02-29
    • Wataru MatsubaraSei KojimaAkira Hino
    • Wataru MatsubaraSei KojimaAkira Hino
    • B60W10/06B60W10/107B60W30/188F02D29/00F16H61/66F16H61/662
    • B60W30/188B60W10/06B60W10/107F02D29/00F16H61/66272F16H2061/6605
    • In a control device for a vehicle on which is mounted a continuously variable transmission capable of mechanically locking a primary pulley at the time of a maximum gear ratio (maximum Low), an idle rotational speed is not always set high to increase a hydraulic pressure at the time of stopping the vehicle. Instead, at the time of stopping the vehicle, when the gear ratio of the continuously variable transmission is the maximum gear ratio, normal idle rotational speed control is performed, and only when the gear ratio is not the maximum gear ratio, idle-up control is performed so that the idle rotational speed is set high, thereby the hydraulic pressure is set high. Thus, by restricting conditions in which the hydraulic pressure is set high by the idle-up control, it is possible to improve fuel efficiency while suppressing generation of a belt slip.
    • 在车辆的控制装置中,其安装有能够在最大变速比(最大低)时机械地锁定主滑轮的无级变速传动装置,怠速转速并不总是设定得很高以增加液压在 停车时间 相反,在车辆停车时,当无级变速器的变速比为最大变速比时,进行正常的怠速转速控制,只有当变速比不是最大变速比时,空转控制 进行怠速转速设定为高,从而将液压设定得高。 因此,通过限制通过怠速控制将液压设定得高的条件,可以在抑制皮带滑移的产生的同时提高燃料效率。
    • 4. 发明授权
    • Operation control system for a shredder
    • 破碎机操作控制系统
    • US5207390A
    • 1993-05-04
    • US746408
    • 1991-08-16
    • Yoshitaka IkedaNoriyuki AkasakaHisataka YonezawaWataru MatsubaraEtsuko KinoshitaHidetaka Ono
    • Yoshitaka IkedaNoriyuki AkasakaHisataka YonezawaWataru MatsubaraEtsuko KinoshitaHidetaka Ono
    • B02C25/00
    • B02C25/00
    • A control system for a refuse shredder composed of a refuse feeding section and a refuse shredding section detects a stagnating state of refuse to adjust the feed rate, detects idling of the feeding section and restores it to a proper state, detects a tendency of tripping of a shredder drive motor and prevents such tripping, and generally automates an operation of the shredder. The system includes an image pickup device for picking up an image of a refuse inlet of the shredder, an image processor for binary-coding an image signal generated by the image pickup device to obtain a characteristic quantity of the refuse, and control calculator for calculating and outputting a control signal for controlling the feeding section and the shredding section on the basis of the characteristic quantity of the refuse obtained by the image processor. Preferably, the system further includes a current detector for detecting a drive current value of a drive motor for the feeding section and the shredding section, and the control calculator calculates and outputs a control signal for controlling the feeding section and the shredding section on the basis of the above-mentioned characteristic quantity of the refuse as well as the detected drive current value of the drive motor.
    • 由垃圾送料部和垃圾粉碎部组成的垃圾粉碎机的控制系统检测停止状态的垃圾调整进给速度,检测供给部的空转并将其恢复到适当的状态,检测到脱扣的倾向 切碎机驱动马达并防止这种脱扣,并且通常使切碎机的操作自动化。 该系统包括用于拾取粉碎机的垃圾入口的图像的图像拾取装置,用于对由图像拾取装置生成的图像信号进行二进制编码以获得垃圾的特征量的图像处理器,以及用于计算 并根据由图像处理器获得的垃圾的特征量,输出用于控制供给部和粉碎部的控制信号。 优选地,该系统还包括电流检测器,用于检测用于馈电部分和粉碎部分的驱动电动机的驱动电流值,并且控制计算器基于该方式计算并输出用于控制馈电部分和粉碎部分的控制信号 的上述垃圾的特征量以及检测到的驱动电动机的驱动电流值。