会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明专利
    • Switch circuit
    • 开关电路
    • JPS59182624A
    • 1984-10-17
    • JP5514383
    • 1983-04-01
    • Hitachi LtdHitachi Micro Comput Eng Ltd
    • SEKIGUCHI SATOSHIKAWAMOTO MIKIHIKOKATOU NORIHISA
    • H01H47/00H03K17/18
    • H03K17/18
    • PURPOSE:To use all switches of a switch circuit for interruption and switching of a signal transmission path by installing an LED to an input side of the switch circuit and lighting the LED without using the switch of the switch circuit itself. CONSTITUTION:A power supply as a control signal is applied to a coil L1 by turning on a switch S0. A current I1 flows also to an LEDD1 and a resistor R1 to light the LEDD1. Then, a switch S1 is turned on by a magnetic field generated from the coil L1 and a moving contact (c) of a switch S2 is changed over from a fixed contact (b) to a fixed contact (a). The coil L1 is energized by this circuit and the LEDD1 is lighted at the same time when the switches S1, S2 are activated, then the operating state of the switch circuit is confirmed by observing visually the light of the LEDD1.
    • 目的:使用开关电路的所有开关,通过将LED安装到开关电路的输入端并点亮LED而不使用开关电路本身的开关来中断和切换信号传输路径。 构成:通过接通开关S0将作为控制信号的电源施加到线圈L1。 电流I1也流向LEDD1和电阻器R1以点亮LEDD1。 然后,开关S1由线圈L1产生的磁场导通,开关S2的移动触头(c)从固定触头(b)转换成固定触点(a)。 线圈L1由该电路通电,并且在开关S1,S2被激活的同时LEDD1点亮,然后通过目视观察LEDD1的光来确认开关电路的工作状态。
    • 3. 发明专利
    • GAIN VARIABLE CIRCUIT
    • JPS6016007A
    • 1985-01-26
    • JP12326983
    • 1983-07-08
    • HITACHI MICROCUMPUTER ENGHITACHI LTD
    • KATOU NORIHISATAKESHITA RITSUJI
    • H03G7/00
    • PURPOSE:To increase the dynamic range and also to obtain an output signal of a low distortion factor by constituting plural stages of a diode load of a gain adjusting circuit and also constituting the amplifier characteristic of an amplifier circuit so as to provide the logarithmic characteristic. CONSTITUTION:Transistors (TR)Q1, Q2 constituted as a differential pair conduct voltage-current conversion. Then a DC voltage E1 and a resistor R1 decide a bias voltage of the TRQ1. Thus, a voltage E1 and an input signal V1 are applied superimposingly to a base of the TRQ1. Further, n-sets of diodes Dn1 connected in series are activated as a load circuit of the TRQ1 and n-sets of diodes Dn2 are operated as a load circuit of the TRQ2 so as to form the amplifier characteristic into a logarithmic characteristic. The gain adjustment of a gain adjusting circuit 2 is conducted by current supply amount of the current control circuits 2a, 2b. Then in increasing/decreasing a current i13 by the control of a current control circuit 3a, the charging current to a capacitor C1 is controlled and the frequency characteristic of an output signal V011 is adjusted by the charging time and discharging time based on the capacitance of the capacitor C1.
    • 4. 发明专利
    • AUDIO AMPLIFIER
    • JPS5662408A
    • 1981-05-28
    • JP13765879
    • 1979-10-26
    • HITACHI LTD
    • KATOU NORIHISA
    • H03F1/00H03F1/30
    • PURPOSE:To reduce the production of pop sound at the reapplication of power supply, by providing an reverse current blocking circuit with a transistor which keeps the output potential for a given time at ''0'' to reduce the production of pop sound at the application of power supply. CONSTITUTION:When a power switch SW is closed, driving transistors Q6, Q7 are also conductive since transistors Q12, Q13 are conductive. Thus, transistors Q8, Q9 at the push-pull output stage are conductive to keep the output voltage to ground level. When the charging of a capacitor C2 advances, the base potential of Q12, Q13 is increased to keep the transistors of both uonconductive. When SW is open, the base potential of Q 2 os slowly lowened than that of Q1 with the operation of an reverse current remains ground level. In this case, no output is produced until Q1 and Q2 are balanced even if power supply is reapplied.
    • 6. 发明专利
    • GAIN VARIABLE CIRCUIT
    • JPS6016006A
    • 1985-01-26
    • JP12326883
    • 1983-07-08
    • HITACHI MICROCUMPUTER ENGHITACHI LTD
    • KATOU NORIHISA
    • H03G9/00H03G5/02
    • PURPOSE:To adjust easily a gain and a frequency characteristic by providing a control section controlling an output level of a gain adjusting circuit and controlling the frequency characteristic of a frequency characteristic adjusting circuit so as to control a control signal applied to this control section. CONSTITUTION:An input signal V1 is superimposed on a DC voltage E1 and the result is applied to a base of a transistor (TR)Q1. Further, resistors R2, R3 are provided to adjust the region where TRs Q1, Q2 are operated as a differential amplifier. Further, diodes D1, D2 conducts a curent-voltage converting operation and decides a voltage level at a point (a) to a prescribed value. Moreover, current control circuits 2a, 2b control currents i1, i2 flowing to the diodes D1, D2. Then in increasing/decreasing a current i13 by the control of a current control circuit 3a, the charging current of a capacitor C1 is controlled. The frequency characteristic of an output signal V011 is adjusted by the charging time and discharge time based on the capacitor C1.
    • 10. 发明专利
    • PUSHHPULL CIRCUIT
    • JPS55143809A
    • 1980-11-10
    • JP5027379
    • 1979-04-25
    • HITACHI LTDHITACHI OME ELECTRONIC CO
    • SEKI KUNIOKATOU NORIHISA
    • H03F3/18H03F3/20H03F3/213H03F3/30
    • PURPOSE:To prevent degradation of the distortion rate dependent upon secondary higher harmonic and so on, by constituting a circuit, by which positive and negative half-wave outputs are obtained, as an inverted Darlington output circuit practically. CONSTITUTION:The output of amplifying transistor TRQ3 which forms the class A amplification output signal of an input signal is input to the base of driving transistor TRQ2 in the side where a negative half-wave output is formed, and the output of amplifying TRQ5 which forms the class A amplification output signal of an input signal, which is level-shifted in level shift circuits Q6 and Q7, is inverted through the current Miller circuit constituted by npn TRQ8 and Q9 and is input to the base of driving transistor TRQ1 in the side where a positive half-wave output is formed. For bias set of TRQ2, diode-connected TRQ10 is provided between the base of TRQ2 and the common emitter of TRQ8 and Q9, and constant-current circuit I02 is provided for the common emitter of TRQ8 and Q9, and constant-current circuit I01 is provided in the collector side of TRQ8. As a result, degradation of the distortion rate dependent upon the secondary higher harmonic and so on can be prevented.