会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 8. 发明专利
    • COMBUSTION CONTROLLER
    • JPH04131613A
    • 1992-05-06
    • JP25327490
    • 1990-09-21
    • MATSUSHITA ELECTRIC IND CO LTD
    • IMAI HIROHISATAKEMURA KOICHIMATSUDA YUKIKAZUTAKIGUCHI MASAHIRO
    • F23N5/12
    • PURPOSE:To correctly judge normal combustion or abnormal combustion and secure the safety by providing two levels of a set volume of excess air and set volume of excess fuel that are beforehand specified and adopting either one of them as a set value by the signal from a combustion controller and stopping the fuel supply means when the flame current is lower than the set value. CONSTITUTION:When a specified time has passed after starting combustion and the combustion is stabilized, detection is started. The flame current If that flows to a burner 1 from a flame rod 2 is detected by a flame current detection circuit 11. Here, in a state wherein the supplied air volume is fixed, a state judgement section 12 increases the oscillation frequency of a pump 6 a little. In the pump 6 the oscillation frequency is roughly proportional to the fuel supply volume, and if the frequency is increased a little, the fuel supply volume increases and the primary air ratio mubecomes smaller. Here, if the flame current If increases mu>mu0, is judged, and if If decreases, a state judgement section 12 judges that mu
    • 10. 发明专利
    • ODOR ABSORPTION CONTROL DEVICE OF WICK TYPE KEROSENE BURNER
    • JPH03177706A
    • 1991-08-01
    • JP31612989
    • 1989-12-05
    • MATSUSHITA ELECTRIC IND CO LTD
    • TAKIGUCHI MASAHIRONAKAMURA SHINICHI
    • F23D3/18F23Q25/00
    • PURPOSE:To enable to start the odor absorption operation at the time of ignition with a suitable timing by starting a timer circuit for the time of ignition for the first time after the completion of ignition by an ignition heater and starting the rotation of an odor absorption fan. CONSTITUTION:When an ignition knob 48 is pressed down, an ignition switch is turned ON and an ignition heater 2 is energized, and an ignition signal 22 is on the level LOW. The ignition signal 22 is inputted to a gate 11a of an ignition timer circuit 11, and the output of the gate 11a is on the level HIGH so that a condenser 15 is charged through a diode 12 and a resistor 13. After the ignition, when the ignition knob 48 is released, an ignition switch 4 is turned OFF, and the electric current to the ignition heater 2 is stopped and the ignition signal 22 is on the level HIGH. At this time the output of the gate 11a is on the level LOW and the condenser 15 starts discharging through a resistor 14. And, the output of a gate 11c is on the level HIGH and it is transmitted to an odor absorption motor driving circuit 23 as an odor absorption motor drive permission signal, and an odor absorption motor 21 starts rotation.