会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Optical receiving circuit and optical communication device
    • 光接收电路和光通信设备
    • US06760552B1
    • 2004-07-06
    • US09532420
    • 2000-03-23
    • Akio TajimaHiroaki TakahashiSoichiro ArakiNaoya HenmiYoshihiko SuemuraYoshiharu MaenoSeigo Takahashi
    • Akio TajimaHiroaki TakahashiSoichiro ArakiNaoya HenmiYoshihiko SuemuraYoshiharu MaenoSeigo Takahashi
    • H04B1006
    • H04B10/6931
    • An optical receiving circuit 1 is composed of a preamplifier circuit 2, an output differential amplifier 3 and a mean value holding circuit 4. The optical receiving circuit 1 is connected to a photodetector 5 for receiving an input optical signal and outputting current. For the preamplifier circuit 2, a transimpedance type circuit may also be used. The preamplifier circuit 2 comprises a feedback resistor 21 and a resistor for detecting output voltage 22, the transimpedance gain is 55 dB &OHgr; and 3 dB bandwidth when the photodetector 5 the capacity of which is 0.2 pF is connected to its output is 8 GHz. The output differential amplifier 3 discriminates and regenerates data by regulating reference voltage Vref between the high level and the low level of the amplitude of an input signal. The mean value holding circuit 4 includes a sample-hold circuit 41 and capacity 42 for holding the mean value of voltage output from the preamplifier circuit 2. As a CR time constant based upon the capacity 42 and the resistor for detection 22 is 1 ns., the mean value level of a received signal can be detected in approximately one byte of the data of 10 Gb/s. The sample-hold circuit 41 samples the detected mean value level according to a sampling pulse from an external device and holds it. The output of the sample-hold circuit 41 is used for the reference voltage of the differential amplifier 3.
    • 光接收电路1由前置放大电路2,输出差分放大器3和平均值保持电路4组成。光接收电路1连接到用于接收输入光信号并输出​​电流的光电检测器5。 对于前置放大器电路2,也可以使用跨阻型电路。 前置放大器电路2包括反馈电阻器21和用于检测输出电压22的电阻器,当其电容为0.2pF的光电检测器5连接到其输出端时,跨阻增益为55dBΩ和3dB带宽为8GHz。 输出差分放大器3通过调节输入信号的幅度的高电平和低电平之间的参考电压Vref来识别和再生数据。 平均值保持电路4包括采样保持电路41和用于保持从前置放大器电路2输出的电压的平均值的电容42.由于基于电容42和检测电阻22的CR时间常数为1ns。 可以在10Gb / s的数据的大约一个字节中检测接收信号的平均值电平。 采样保持电路41根据来自外部设备的采样脉冲对检测到的平均值电平进行采样并保持。 采样保持电路41的输出用于差分放大器3的参考电压。
    • 3. 发明授权
    • Optical network
    • 光网络
    • US06429955B1
    • 2002-08-06
    • US09218102
    • 1998-12-22
    • Yoshihiko SuemuraSoichiro ArakiAkio TajimaSeigo TakahashiYoshiharu MaenoNaoya Henmi
    • Yoshihiko SuemuraSoichiro ArakiAkio TajimaSeigo TakahashiYoshiharu MaenoNaoya Henmi
    • H04J1402
    • H04Q11/0001
    • Disclosed is an optical network which has: wavelength tunable optical transmitters of number MN, where N is an integer of two or more, each of which outputs an optical signal with arbitrary one of M wavelengths &lgr;1, &lgr;2, . . . , &lgr;M, where M is an integer of two or more, that are different from one another; a MN×N optical switch whose input ports are connected to the respective wavelength tunable optical transmitters of number MN, and which allows optical signals input to different input ports to be output form its same output port; 1×M optical wavelength demultiplexers of number N which output demultiplexing optical signal with wavelengths &lgr;1, &lgr;2, . . . , &lgr;M input from output ports of the MN×N optical switch into each wavelength; and optical receivers of number MN which receive optical signals input from the 1×M optical wavelength demultiplexers of number N.
    • 公开了一种光网络,其具有:号MN的波长可调光发射机,其中N是两个或更多个的整数,每个都输出具有M个波长lambd1,lambd2的任意一个的光信号。 。 。 ,lambdM,其中M是两个或更多个彼此不同的整数; 一个MNxN光开关,其输入端口连接到MN号的各波长可调光发射机,并允许输入到不同输入端口的光信号从其相同的输出端口输出; 数字N的1xM光学波长解复用器,其输出具有波长lambd1,lambd2的解复用光信号。 。 。 ,将MNxN光开关的输出端口的lambdM输入到每个波长; 数字MN的光接收器接收从数字N的1MM光波分复用器输入的光信号。
    • 9. 发明授权
    • Data transmission system using specific pattern for synchronization
    • 数据传输系统采用特定的模式进行同步
    • US5887039A
    • 1999-03-23
    • US356555
    • 1994-12-15
    • Yoshihiko SuemuraNaoya HenmiAkio Tajima
    • Yoshihiko SuemuraNaoya HenmiAkio Tajima
    • H04J3/00H04J3/06H04L7/00H04L7/04H04L25/14
    • H04L25/14H04J3/0602
    • Parallel digital data are transmitted along with a specific synchronization pattern added thereto. Each synchronization pattern adder adds the synchronization pattern at an equal timing for each channel. Parallel data after the synchronization pattern addition, are converted in parallel-to-serial converters into serial data which are in turn converted in an optical transmitter into optical signal. On the receiving side, the optical signal is converted in an optical receiver into an electric signal, from which the parallel data are restored in serial-to-parallel converters to be inputted to synchronization pattern detectors. The synchronization pattern detectors compare their shift register data and synchronization pattern and hold their synchronization pattern detection signal to be "1" for one time slot if the number of non-accord bits is within one. In the next time slot, a controller recognizes synchronization pattern detection when and only when all the synchronization pattern detection signals are "1". In this way, reliable synchronization pattern detection can be made regardless of the occurrence of any transmission error in the synchronization pattern.
    • 平行数字数据与添加到其中的特定同步模式一起发送。 每个同步模式加法器在每个通道的相同定时添加同步模式。 在同步模式添加之后的并行数据被并行转换为串行数据转换为串行数据,这些数据依次在光发射机中转换为光信号。 在接收侧,光信号在光接收机中被转换成电信号,并行数据在并行转换器中被还原,以被输入到同步模式检测器。 同步模式检测器比较它们的移位寄存器数据和同步模式,并且如果非协调位的数目在一个之内,则将它们的同步模式检测信号保持为一个时隙的“1”。 在下一个时隙中,当且当所有同步模式检测信号为“1”时,控制器识别同步模式检测。 以这种方式,可以进行可靠的同步模式检测,而不管同步模式中是否发生任何传输错误。