会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明申请
    • ON-HOOK/OFF-HOOK DETECTOR CIRCUIT
    • 挂钩/离线检测电路
    • WO1982002307A1
    • 1982-07-08
    • PCT/US1980001699
    • 1980-12-22
    • MOSTEK CORPDAVIS HAROLD LOUIS
    • MOSTEK CORP
    • H04M03/22
    • H04M3/2272H04M1/82
    • An on-hook/off-hook detector circuit (10) is included within a telecommunication integrated circuit. A tone generator power signal (V u) is monitored as a status signal to determined when a telephone switch hook is in either an on-hook or off-hook condition. The tone generator power signal is subject to interference and transients which prevents direct utilization of it to indicate on-hook and off-hook conditions. A resistor (20) and capacitor (22) are connected externally to the circuit (10) at a junction terminal (16) to provide a time delay following a transition of the status signal (V u). The junction terminal of the resistor (20) and capacitor (22) is held at two transistor threshold voltages below the upper supply voltage (V +). At the time of transitions of the status signal CV u the junction terminal (16) is disconnected from a current path such that the terminal (16) is permitted to charge the capacitor (22) through the resistor (20). When the capacitor (22) has charged up to within one threshold voltage of the positive power terminal (V +) a transistor (48) is turned off thereby permitting the on-hook signal at line (50) to be driven negative thereby reliably indicating that the switch hook has been placed in the on-hook condition. The charging of the capacitor (22) serves as a time delay to eliminate faulty signal indications derived from noise and transients associated with the status signal (V u).
    • 一个挂机/摘机检测电路(10)被包括在电信集成电路内。 监听音调发生器功率信号(V uu u)作为状态信号,以确定电话切换钩何时处于挂机或摘机状态。 音调发生器功率信号受到干扰和瞬变,防止其直接使用以指示挂机和摘机状况。 电阻器(20)和电容器(22)在接线端子(16)处外部连接到电路(10),以在状态信号(V u> u)的转变之后提供时间延迟。 电阻器(20)和电容器(22)的接线端子保持在低于上电源电压(V +)的两个晶体管阈值电压。 在状态信号CV 的转换时,接线端子(16)与电流路径断开,使得端子(16)被允许通过电阻器(20)对电容器(22)充电。 当电容器(22)已经充电到正电源端子(V +)的一个阈值电压内时,晶体管(48)被断开,从而允许线路(50)处的挂机信号被驱动为负,从而可靠地指示 开关钩已经处于挂机状态。 电容器(22)的充电用作时间延迟,以消除从与状态信号(V u> u)相关联的噪声和瞬变导出的故障信号指示。