会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 44. 发明授权
    • Systems and arrangements for clock and data recovery in communications
    • 通信中时钟和数据恢复的系统和安排
    • US07916820B2
    • 2011-03-29
    • US11608962
    • 2006-12-11
    • Hayden C. Cranford, Jr.Daniel J. FriedmanMounir MeghelliThomas H. Toifl
    • Hayden C. Cranford, Jr.Daniel J. FriedmanMounir MeghelliThomas H. Toifl
    • H04L7/00
    • H04L7/0004H04L7/0334
    • A dual mode clock and data recovery (CDR) system is disclosed. A fast locking, oversampling CDR acquisition module can begin the process to quickly create a data acquisition clock signal in start up data acquisition conditions. When at least some data can be extracted from the incoming data stream, the CDR system can indicate such stability and switch to accept control from a low power CDR maintenance module. The low power CDR maintenance module can then fine tune and maintain the timing of the data acquisition signal. If the quality of the data lock under CDR maintenance module control degrades to a sufficient degree, the high power CDR acquisition module can be re-enables and re-assert control from the low power module until such time as the lock quality is again sufficient for the low power module to be used.
    • 公开了一种双模式时钟和数据恢复(CDR)系统。 快速锁定,过采样CDR采集模块可以开始该过程,以在启动数据采集条件下快速创建数据采集时钟信号。 当从输入数据流中至少提取一些数据时,CDR系统可以指示这种稳定性,并切换到接受来自低功率CDR维护模块的控制。 低功率CDR维护模块可以微调并保持数据采集信号的定时。 如果CDR维护模块控制下的数据锁定质量下降到足够的程度,高功率CDR采集模块可以重新启用并重新从低功率模块重新进行控制,直到锁定质量再次足够 要使用的低功耗模块。
    • 46. 发明授权
    • System and circuit for constructing a synchronous signal diagram from asynchronously sampled data
    • 用于从异步采样数据构建同步信号图的系统和电路
    • US07792649B2
    • 2010-09-07
    • US12055317
    • 2008-03-26
    • Hayden C. Cranford, Jr.Fadi H. GebaraJeremy D. Schaub
    • Hayden C. Cranford, Jr.Fadi H. GebaraJeremy D. Schaub
    • G06F19/00
    • H04L1/205G01R31/31709
    • A system and circuit for constructing a synchronous signal diagram from asynchronous sampled data provides a low cost and production-integrable technique for providing a signal diagram. The data signal is edge-detected and asynchronously sampled (or alternatively a clock signal is latched). The data signal or a second signal is compared to a settable threshold voltage and sampled. The edge and comparison data are folded according to a swept timebase to find a minimum jitter period. The crossing of the signal diagram edges is determined from a peak of a histogram of the folded edge data. A histogram of ratios of the sample values versus displacement from the position of the crossing location is generated for each threshold voltage. The technique is repeated over a range of settable threshold voltages. Then, the ratio counts are differentiated across the histograms with respect to threshold voltage, from which a signal diagram is populated.
    • 用于从异步采样数据构建同步信号图的系统和电路为提供信号图提供了低成本和生产可集成技术。 数据信号被边缘检测和异步采样(或者时钟信号被锁存)。 将数据信号或第二信号与可设置的阈值电压进行比较并采样。 边缘和比较数据根据扫描时基折叠以找到最小抖动周期。 信号图边缘的交叉由折叠边缘数据的直方图的峰值确定。 对于每个阈值电压产生样本值与交叉位置位置之间的位移比率的直方图。 该技术在可设置的阈值电压范围内重复。 然后,相对于阈值电压,在直方图之间区分比率计数,从中填充信号图。
    • 49. 发明授权
    • CML delay cell with linear rail-to-rail tuning range and constant output swing
    • CML延迟单元具有线性轨至轨调谐范围和恒定输出摆幅
    • US07541855B2
    • 2009-06-02
    • US12124384
    • 2008-05-21
    • Hayden C. Cranford, Jr.Marcel A. KosselThomas E. Morf
    • Hayden C. Cranford, Jr.Marcel A. KosselThomas E. Morf
    • H03H11/26
    • H03K5/13H03K5/133H03K2005/00032H03K2005/00208
    • A current mode logic (CML) delay cell with linear rail-to-rail tuning range and constant output swing. The CML delay cell can include a tuning voltage input on a first and second transistor, contributing to a CML delay cell load, and a bias voltage input on a third transistor, as a current source I0, and a compensation circuit having switching point optimized inverters having a first plurality of transistors having a transconductance βpN and a second plurality of transistors having a transconductance βnN, wherein respective ratios of βnN/βpN determine an inverter switching point of respective switching point optimized inverters, the first and second plurality of transistors having gates coupled to the tuning voltage input of the CML delay cell, wherein the switching point optimized inverters are followed by weighted tail current sources M0N that supply additional currents to the current source I0 at a drain node of the third transistor.
    • 具有线性轨至轨调谐范围和恒定输出摆幅的电流模式逻辑(CML)延迟单元。 CML延迟单元可以包括在第一和第二晶体管上的调谐电压输入,有助于CML延迟单元负载,以及作为电流源I0在第三晶体管上输入的偏置电压,以及具有开关点优化的逆变器的补偿电路 具有跨导betapN的第一多个晶体管和具有跨导betanN的第二多个晶体管,其中,betanN / betapN的各自比例确定各个开关点优化的反相器的反相器切换点,第一和第二多个晶体管具有栅极耦合 到CML延迟单元的调谐电压输入,其中开关点优化的反相器之后是在第三晶体管的漏极节点向电流源I0提供附加电流的加权尾电流源M0N。