会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明专利
    • MUTING CIRCUIT FOR SAMPLING QUARTZ LOCK CIRCUIT
    • JPS5710535A
    • 1982-01-20
    • JP8426080
    • 1980-06-20
    • SANYO ELECTRIC CO
    • IMAMURA EIGO
    • H04B1/26H03L7/08H04B1/10
    • PURPOSE:To remove the noise at transient response in which the local oscillating frequency starts to be locked, by controlling a voice rejecting circuit also with the rectified output of signals within specific frequency range among the beat signals from a phase comparator. CONSTITUTION:Among the beat signals from a phase comparator in the loop of a sampling quartz lock circuit, a voice rejecting circuit is controlled even with the rectified output of the signals within the specific frequency range. For example, the beat signal from the phase comparator of a lock circuit of an FM receiver is given to the 2nd high-pass filter 21 having lower cutoff frequency than that of the 1st high-pass filter 11 and a transistor TRQ3 via the 2nd rectifier circuit 22. Further, the rectified output of the beat signal having lower frequency in transient response where the local oscillating frequency is locked, turns of the TRQ3, and the output is given to a voice muting TR23 via an NAND gate circuit NG2 to make muting.
    • 4. 发明专利
    • CHANNEL SELECTING CIRCUIT
    • JPS57154928A
    • 1982-09-24
    • JP4108281
    • 1981-03-19
    • SANYO ELECTRIC CO
    • IMAMURA EIGO
    • H03J7/18H03J1/04H03J5/00H03J7/32H04N5/44
    • PURPOSE:To avoid useless display current when plural control means are operated at one time for a channel selecting circuit of a TV picture receiver, etc., by setting a current limiting resistance in series to a light emitting element for channel display. CONSTITUTION:The current supplied from a 32V power supply line 5 is limited to actuate a transistor TRQ4 at a moment when control switches S1 and S2 are operated at one time. At the same time, the current flowing into the 11th pin from the side of a light emitting diode D22 via the switches S2 and S1 is limited by current limiting resistances R22 and R21 and after a low level is set for the 11th pin 11 of a channel selecting IC circuit 1. Thus the light emitting diode is substantially turned off. In this case, the current flowing from the line 5 through a volume VR2 plus the switches S2 and S1 is also limited, and the channel selection state set previously may possibly vary mistakenly. However, a capacitor C5 functions to give no effect to the TRQ4 against the voltage rise at point (c) caused by the mistaken channel display current. Thus the display has no change.
    • 10. 发明专利
    • Vtr for sound multiplex
    • VTR FOR SOUND MULTIPLEX
    • JPS6199479A
    • 1986-05-17
    • JP22085784
    • 1984-10-19
    • Sanyo Electric Co Ltd
    • IMAMURA EIGO
    • H04N5/783H04N9/802
    • H04N9/802H04N5/783
    • PURPOSE:To prevent the occurrence of buzz beat in a special reproducing mode by providing a switch means which switches an encoder circuit to the monaural mode forcibly in accordance with setting of special reproducing states other than the normal reproducing state. CONSTITUTION:The switch means consisting of three switching transistors TRs Q1-Q3 is interposed between the third terminal of an IC 6 and a system controller 5. When a PLAY button 8 on the operation panel of a VTR is turned on and an FF button 80 is turned on, the VTR is set to the cue state by the control of the system controller 5. The TR Q2 is turned on at this time, and thereby, the TR Q1 is turned on, and the input state of the third terminal of the IC 6 falls to the low level. As the result, the mode changeover switch is set to the monaural mode, and a controlling oscillation circuit 62 and a pilot carrier signal generating circuit 63 stop the operation. Thus, a mode discriminating signal P is not mixed with a sound multiplex signal Q obtained from the sixth terminal of the IC 6.
    • 目的:通过提供一种根据除了正常再现状态之外的特殊再现状态的设置强制地将编码器电路切换到单声道模式的开关装置,以防止在特殊再现模式中发生蜂鸣声。 构成:由三个开关晶体管TR-Q1-Q3组成的开关装置插入在IC6的第三端子和系统控制器5之间。当VTR的操作面板上的PLAY按钮8接通时,FF按钮80 导通时,通过系统控制器5的控制将VTR设定为提示状态。此时,TR Q2导通,由此使TR Q1导通,将第三端子的输入状态 IC 6下降到低水平。 结果,模式转换开关被设置为单声道模式,并且控制振荡电路62和导频载波信号发生电路63停止该操作。 因此,模式鉴别信号P不与从IC6的第六端获得的声音多路复用信号Q混合。