会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 2. 发明专利
    • SOLAR SYSTEM FOR GENERATING STEAM
    • JPS63183346A
    • 1988-07-28
    • JP1514187
    • 1987-01-27
    • AGENCY IND SCIENCE TECHNTOSHIBA CORP
    • TANAKA TADAYOSHIMORITA MASANOBU
    • F22B1/02F22B33/18F22D1/00F24S90/00
    • PURPOSE:To reduce the installation space and cost for equipment and installations by providing a first heat exchanger in which heat is exchanged between hot thermal medium heated by collected heat and transported feed water as well as a second heat exchanger which generates steam for processing by heating the feed water with the operating medium. CONSTITUTION:Thermal medium 15 heated to the set temperature by collecting heat in a solar collector 1 exchanges heat with feed water 16 in a heat exchanger 2 where the feed water 16 is heated by the thermal medium 15. As the quantity of heat that can be collected by the solar collector 1 exceeds the set value when the sunshine is abundant, only the set amount regulated by a control valve CV3 is introduced into a heat exchanger 12, and the excessive hot feed water 16 passes through a control valve 4 to be stored in a storage tank 3. The feed water 16 now regulated to the set temperature and set flow rate becomes saturated gas by receiving heat of waste heat source 14 in a heat exchanger 9, which is then compressed in a compressor 10 and exchanges heat with operating medium 17 in the heat exchanger 12. Consequently, the feed water 16 becomes usable steam at still higher temperature and pressure and is supplied to the process.
    • 5. 发明专利
    • FLOW CONTROLLER FOR HEAT EXCHANGER
    • JPH01267306A
    • 1989-10-25
    • JP9158188
    • 1988-04-15
    • TOSHIBA CORP
    • MORITA MASANOBU
    • F01K25/10
    • PURPOSE:To keep flow balance properly all the time by installing a bypass passage among plural numbers of heat exchangers and, when a flow rate of a heating medium passing through each interval among these heat exchangers is fewer than that of a heated medium, bypassing this heated medium. CONSTITUTION:Hot water 1 heats a working fluid 2 by passing through a lot of preheaters 6-10 in regular sequence after passing through an evaporator 5. Then, this working fluid 2 turns to high temperature, pressure steam, driving a turbine 11 to rotate a generator 2, while it is cooled by a condenser 13, coming to a condensate, and it is made to flow back to the evaporator 5 and the preheaters 6-10 again. In this case, a bypass passage 3 is installed side by side in each interval among these preheaters 8-10, and in this bypass passage 3, a lot of control valves 19-21 are provided. When a flow rate of the hot water 1 is fewer than that of the working fluid 2, these control valves 19-21 are opened by an arithmetic and control unit 22, thereby bypassing the working fluid 2 from the preheaters 8-10.
    • 7. 发明专利
    • Sea temperature difference power plant
    • 海温不同发电厂
    • JPS59165873A
    • 1984-09-19
    • JP3743483
    • 1983-03-09
    • Toshiba Corp
    • MORITA MASANOBU
    • F03G7/05F03G7/04
    • F03G7/05Y02E10/34
    • PURPOSE:To improve the efficiency of a plant by providing a tray type water heater in the sea water and taking out hot surface sea water heated by the rays of the sun while sea water is passing through the water heater. CONSTITUTION:A sea temperature difference power plant P takes out hot sea water through a pipe 11 having an opening in hot surface sea water in a tray type water heater T by means of a pump 10, and allows a low boiling point medium to evaporate by means of an evaporator 12, making the evaporated medium drive a turbine 14 through a pipe 13. The hot water is again returned to the tray type water heater T through a pipe 20, heated by the rays of the sun while it flows in the tray, and circulated with a raised temperature, thereby improving the efficiency of the plant.
    • 目的:通过在海水中提供托盘式热水器并在海水通过热水器时取出由太阳光线加热的热表面海水,从而提高工厂的效率。 构成:海温差发电厂P通过泵10在托盘式热水器T中通过热表面海水中的开口的管道11取出热海水,并通过泵10使低沸点介质蒸发 蒸发器12的装置,使得蒸发的介质通过管道13驱动涡轮14.热水通过管20再次返回到托盘式热水器T,管20在太阳光线在托盘 并以升高的温度循环,从而提高了植物的效率。
    • 8. 发明专利
    • Plant utilizing solar heat
    • 植物利用太阳能热
    • JPS5913855A
    • 1984-01-24
    • JP12385482
    • 1982-07-16
    • Agency Of Ind Science & TechnolToshiba Corp
    • TANI TATSUOSAWADA SHINJITANAKA TADAYOSHISAKUTA KOUICHITSUDA IZUMINAKAMOTO YASUHATSUSEKIYA EIJIMORITA MASANOBUSHIMOMURA KATSUMIISHII HIDEMASA
    • F24J2/42F24J2/46
    • F24J2/4632Y02E10/40
    • PURPOSE:To prevent breakdown of a system due to freezing of a heat transfer medium during stoppage of operation, by transferring the collected solar energy to the heat transfer medium to feed it to a power generating installation and utilities. CONSTITUTION:A first solar heat collector 5 collects the solar heat energy and transfer the energy to an anti-freezing primary heat transfer medium (a) such as heat transfer oil, an anti-freezing solution. The heat transfer medium (a) is fed through a line 6 to a steam generator 7 where the steam serving as a secondary heat transfer medium (b) is generated through heat exchange of the heat transfer medium with the secondary heat transfer medium (b). Further, in case the steam is supplied to a power generating system, the solar heat energy is converted into a mode in which the solar heat energy is easy to utilize, whereby the steam serving as the secondary medium (b) is supplied to a second collector 8 where the medium is increased in temperature and is supplied through a line 9 to the power generating system. This permits the prevention of the occurrence of breakdown while the system suspends operating during the night.
    • 目的:为了防止在运转中停止传热介质导致的系统故障,通过将收集到的太阳能转移到传热介质上,将其送入发电设备和设备。 构成:第一太阳能热收集器5收集太阳能热能并将能量转移到防冻一次传热介质(a),例如传热油,防冻溶液。 传热介质(a)通过管线6供给到蒸汽发生器7,在蒸汽发生器7中,通过传热介质与二次传热介质(b)的热交换产生用作二次传热介质(b)的蒸汽, 。 此外,在将蒸汽供给到发电系统的情况下,将太阳能热转换为太阳能热能易于利用的模式,由此将作为二次介质(b)的蒸汽供给到第二 集电器8,其中介质温度升高并且通过管线9供应到发电系统。 这样可以防止系统在夜间停机时发生故障。
    • 9. 发明专利
    • Solar heat collector
    • 太阳能热收集器
    • JPS5913850A
    • 1984-01-24
    • JP12385582
    • 1982-07-16
    • Agency Of Ind Science & TechnolToshiba Corp
    • TANI TATSUOSAWADA SHINJITANAKA TADAYOSHISAKUTA KOUICHITSUDA IZUMINAKAMOTO YASUHATSUSEKIYA EIJIMORITA MASANOBUSHIMOMURA KATSUMIISHII HIDEMASA
    • F24J2/42F24J2/00
    • F24J2/00Y02E10/40
    • PURPOSE:To improve the setting density of a solar heat collector group and to enable effective utilization of a setting space, by locating a flat type or other type solar heat collector in a space between the collectors situated at given intervals. CONSTITUTION:A solar heat collector 1 consists of a plurality of light collecting type solar heat collectors 1a-1c, and flat type or other type, for example, each of vacuum tube type collectors 10a, 10b,..., which are capable of collecting scattering rays, is positioned in a space X between the solar heat collectors so that incidence of the solar rays to the collectors (1a-1c...) is prevented from interference with each other. This constitution, during movement of the sun between A-A, enables heat to be fully collected, and, for example, even if the collectors 1a-1c shade vacuum tube type, scattering light can be collected, resulting in increasing collection of the solar rays in any case.
    • 目的:通过将扁平型或其他类型的太阳能热收集器定位在以给定间隔设置的收集器之间的空间中,以提高太阳能集热器组的设定密度并且有效利用固定空间。 构成:太阳能热收集器1由多个集光型太阳能集热器1a-1c和扁平型或其他类型的真空管式集尘器10a,10b,...组成,它们能够 收集散射光线位于太阳能集热器之间的空间X中,从而防止太阳能射线到集电体(1a-1c ...)的相互干扰。 这种构造在AA之间的太阳运动期间能够使热量被完全收集,并且例如即使集尘器1a-1c遮蔽真空管型,也可以收集散射光,导致太阳射线的收集增加 任何情况。
    • 10. 发明专利
    • HEAT EXCHANGER CONTROL DEVICE FOR GENERATING PLANT
    • JPS6460703A
    • 1989-03-07
    • JP21628487
    • 1987-09-01
    • TOSHIBA CORP
    • MORITA MASANOBU
    • F01K25/10F03G4/00F03G7/04
    • PURPOSE:To enable stable operation of a generating plant by cutting off the flow of a secondary medium to at least some preheater of plural preheaters as heat exchangers for preheating the secondary medium to be passed through a by-path. CONSTITUTION:While the secondary medium 10 is passed from the first preheater 8 to the sixth preheater 3, it is subjected to energy of hot water 1 to be preheated and changed into high-temperature and high-pressure vapor by an evaporator 2 to drive a turbine 11 and rotate a generator 12. Now, if the flow rate of hot water 1 is remarkably lowered than a design point, when the difference between the decreased heat exchanger duty and the heat exchanger duty decreased at the evaporating portion 2 is larger than the heat exchanger duty of the first preheater 8, according to a control signal from an arithmetic unit, a control valve 20 is closed and a control valve 24 is opened. The secondary medium 10 is passed through a by-pass line 22 not to be heat- exchanged at the first preheater 8. Accordingly, at the sixth preheater 3, the evaporation of the secondary medium can be prevented to avoid pressure change in the secondary medium system and an increase in pressure loss, so that the generating plant can be operated stably.