会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 4. 发明授权
    • Ignition system for internal combustion engine
    • 内燃机点火系统
    • US4105006A
    • 1978-08-08
    • US703780
    • 1976-07-09
    • Werner JundtPeter WernerBernd BodigGerhard SohnerHelmut Roth
    • Werner JundtPeter WernerBernd BodigGerhard SohnerHelmut Roth
    • F02P3/04F02P3/045F02P3/05F02P3/02
    • F02P3/051
    • Current flow to the ignition coil during low-speed operation of the engine, is controlled by an auxiliary control switch which is connected in shunt with the primary of the ignition coil. Serially connected with the primary is a main control switch which is controlled to close until current through the primary has reached a certain value, at which time the main switch opens and the shunt auxiliary switch is closed to permit continued inductive current flow through the coil and thus store ignition energy, the cycle repeating to maintain current flow through the primary at a level to store sufficient energy for the ignition spark which, at the ignition instant, effects opening of the shunt circuit by opening the auxiliary switch while also opening the circuit to the primary, thus providing a high-voltage pulse which provides for sparking of the spark plug. The sensor for current flow through the primary is preferably a resistor which, when the voltage drop thereacross exceeds a predetermined level, controls changeover of a transistor.
    • 在发动机的低速运行期间到点火线圈的电流流量由辅助控制开关控制,辅助控制开关与点火线圈的初级线路分流连接。 与初级系统连接的是主控制开关,其被控制为关闭,直到初级电流达到一定值,此时主开关打开并且分流辅助开关闭合,以允许持续的感应电流流过线圈, 因此存储点火能量,循环重复以维持电流流过初级,以保持点火火花的足够的能量,该点火火花在点火瞬间通过打开辅助开关来实现分流回路的打开,同时打开电路 从而提供高电压脉冲,其提供火花塞的火花。 用于流过初级电流的电流传感器优选是电阻器,当超过预定电平的电压降时,控制晶体管的切换。
    • 5. 发明授权
    • Ignition system with improved temperature and voltage compensation
    • 点火系统具有改善的温度和电压补偿
    • US4253442A
    • 1981-03-03
    • US60878
    • 1979-07-26
    • Werner JundtBernd BodigGerd HohneGeorg PfaffGerhard SohnerBernd Kalkhof
    • Werner JundtBernd BodigGerd HohneGeorg PfaffGerhard SohnerBernd Kalkhof
    • F02P3/04F02P3/045F02P3/05F02P1/00
    • F02P3/051
    • The voltage across a capacitor is changed in a first direction while the current in the primary winding of the ignition coil increases to a predetermined value less than the value required for ignition and is thereafter changed in a second direction until ignition takes place. The voltage across the capacitor is applied to the inverting input of a difference amplifier constituting a threshold stage controlling the initiation and termination of current flow through the ignition coil. The two changes are symmetrical when the engine speed remains constant. The residual voltage across the capacitor at the end of the second change is maintained until the start of the next subsequent first change, so that the time at which the threshold stage switches in, that is the time at which primary current starts to flow in the ignition coil changes as a function of the residual voltage in the capacitor.
    • 电容器两端的电压在第一方向上变化,同时点火线圈的初级绕组中的电流增加到小于点火所需值的预定值,然后在第二方向上改变直到发生点火。 电容器两端的电压被施加到构成阈值级的差分放大器的反相输入,该阈值级控制通过点火线圈的电流的启动和终止。 当发动机转速保持恒定时,两个变化是对称的。 在第二次变化结束时,电容器两端的剩余电压被维持直到下一个随后的第一次改变开始,使得阈值级切换的时间,即初级电流开始流过的时间 点火线圈根据电容器中的残余电压而变化。
    • 7. 发明授权
    • Motor ignition system control circuit for maintaining energy storage in
spark coil constant in wide speed range
    • 电机点火系统控制电路,用于保持火花线圈的能量存储在宽速度范围内恒定
    • US4176645A
    • 1979-12-04
    • US734745
    • 1976-10-22
    • Werner JundtGerhard SohnerPeter WernerHerman Roozenbeek
    • Werner JundtGerhard SohnerPeter WernerHerman Roozenbeek
    • F02P3/04F02P3/045F02P3/05F02P1/00
    • F02P3/0453
    • A monitoring resistor in series with the spark coil primary winding and the electronic interruptor switch provides a signal to an integrator for shifting the control thresholds of a threshold switch that controls the interruptor away from their quiescent values that are nearer the zero crossover of the timing voltage wave provided by an engine driven timing signal generator. The integrator output voltage remains constant during the time the interruptor switch is open. While current flows through the interruptor circuit, the integrator increases the control voltage until the primary winding current reaches a predetermined level and then decreases the control voltage until the timing wave recloses the interruptor. While the control voltage is being decreased, the coil current is allowed to rise to a limiting value and is then held constant by another circuit controlled by the monitoring resistor that slightly reduces the conductivity of the interruptor switch in its closed condition, but this occurs only while the engine is accelerating to the operating speed range. During this time the switch-on threshold for controlling the interruptor is raised towards the peak of the timing wave, but the switch-off threshold is clamped to its initial value. With further increase in engine speed, the net effect of the integrator operation changes sign and the switch-on threshold is lowered. As soon as the switch-on threshold goes below its initial value, the switch-off threshold is unclamped and is depressed along with the switch-on threshold towards the negative peak of the timing wave by the integrator action. The result is to keep the amount of energy stored in the spark coil at the time of primary circuit interruption constant over a wide range of speed.
    • 与火花线圈初级绕组和电子中断器开关串联的监测电阻器向积分器提供信号,以将控制该断路器的阈值开关的控制门限移离其偏离定时电压零交叉的静态值 由发动机驱动的定时信号发生器提供的波。 积分器输出电压在断路器开关断开期间保持恒定。 当电流流过中断电路时,积分器增加控制电压,直到初级绕组电流达到预定电平,然后减小控制电压,直到定时波重新闭合中断器。 当控制电压降低时,允许线圈电流上升到极限值,然后由监控电阻控制的另一个电路保持恒定,这样可以在闭合状态下稍微降低断路器开关的导通性,但这只会发生 而发动机正在加速到运行速度范围。 在此期间,用于控制中断器的接通阈值向着定时波的峰值升高,但关断阈值被钳位到其初始值。 随着发动机转速的进一步提高,积分器运行的净影响变化,降低了开启阈值。 一旦开启阈值低于其初始值,关闭阈值就被解除锁定,并且通过积分器动作将其与导通阈值一起压向定时波的负峰值。 结果是在主电路中断时保持在火花线圈中存储的能量的数量在宽的速度范围内是恒定的。
    • 8. 发明授权
    • Internal combustion engine ignition system
    • 内燃机点火系统
    • US4253443A
    • 1981-03-03
    • US109625
    • 1980-01-04
    • Karl SeegerWalter RufGerhard SohnerWerner Jundt
    • Karl SeegerWalter RufGerhard SohnerWerner Jundt
    • F02P3/045F02P7/067F02P1/00
    • F02P7/0672F02P3/0456
    • To permit use of shaft position transducers which provide needle pulses at predetermined angular positions of the crankshaft of an engine, such as Wiegand-type, and still enable generation of a counted dwell time even under transient conditions, or under low-speed conditions, the output from the Wiegand transducer is connected to a logic circuit which, under normal operating conditions, by use of a counter counts a predetermined time interval after opening of a switch in series with the ignition coil to determine the dwell period or initiation of current flow for a subsequent ignition event by resetting the counter with a reverse polarity subsequent pulse, thereby passing, upon reset, a predetermined count state which, similar to the normal counting of the count state, initiates closing of the switch. Thus, even though the normal counting time has not yet been reached, the reset operation of the counter will trigger closing of the switch and hence sufficient current flow through the ignition coil to store the appropriate electromagnetic energy therein for a reliable spark at the spark plug.
    • 为了允许使用在诸如Wiegand型发动机的曲轴的预定角度位置处提供针脉冲的轴位置换能器,并且即使在瞬态条件下或者在低速条件下仍然能够产生计数停留时间, 来自韦根传感器的输出连接到逻辑电路,该逻辑电路在正常操作条件下通过使用计数器在与点火线圈串联的开关断开之后计数预定的时间间隔,以确定电流的停留时间或电流的开始 随后的点火事件通过用反极性后续脉冲复位计数器,从而在复位时通过预定的计数状态,其类似于计数状态的正常计数启动开关的闭合。 因此,即使尚未达到正常的计数时间,计数器的复位操作将触发开关的闭合,从而使足够的电流流过点火线圈以在其中存储适当的电磁能,以便在火花塞处产生可靠的火花 。
    • 10. 发明授权
    • Protective case for combination ignition coil and electronic control
    • 组合点火线圈和电子控制的保护壳
    • US4928660A
    • 1990-05-29
    • US327816
    • 1989-03-23
    • Gerhard SohnerHelmut RothHartmut BrammerRichard SchleupenKarl-Heinz Nubel
    • Gerhard SohnerHelmut RothHartmut BrammerRichard SchleupenKarl-Heinz Nubel
    • F02P3/08F02P7/02F02P7/06
    • F02P7/06F02P3/08F02P7/025
    • A protective case (13) for a vehicle ignition system covers both the ignition coil (5), an electronic control device (6), and the terminals (11) and connecting conductors (12) therebetween. The preferred material is plastic, with an electromagnetically conducting coating for screening against incoming and outing electromagnetic noise. Thus, protection is provided against mechanical, chemical, and electromagnetic environmental influences. The case is dimensioned to snap over and seal respective edges of the electronic control device (6), the ignition coil (5) and its core (8), the electrical terminals (11), and the interconnecting conductors (12). The case is bifurcated along an access slit (16) which is secured in a normally closed position by knob (15) which press-fits into a mating hole on the other side of the slit. Two sides of the case have curved ridges or dimples which provide flexibility to hinge the case open for insertion of the ignition coil (5) and electronic control device (6).
    • 用于车辆点火系统的保护壳(13)覆盖点火线圈(5),电子控制装置(6)以及它们之间的端子(11)和连接导体(12)。 优选的材料是塑料,具有电磁导电涂层,用于筛选进入和外出的电磁噪声。 因此,提供对机械,化学和电磁环境影响的保护。 壳体的尺寸被设计成卡扣和密封电子控制装置(6),点火线圈(5)和其芯(8),电端子(11)和互连导体(12)的各个边缘。 壳体沿着通过压配合到狭缝另一侧的配合孔中的把手(15)固定在常闭位置的进入狭缝(16)上分叉。 壳体的两侧具有弯曲的脊或凹坑,其提供弹性以铰接壳体打开以插入点火线圈(5)和电子控制装置(6)。