会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 2. 发明申请
    • METHOD AND DEVICE TO COMPENSATE FOR AN ASYMMETRICAL DC BIAS CURRENT IN A POWER TRANSFORMER CONNECTED TO A HIGH VOLTAGE CONVERTER
    • 补偿连接到高电压转换器的电力变压器中的非对称直流偏置电流的方法和装置
    • WO2009026968A1
    • 2009-03-05
    • PCT/EP2007/059132
    • 2007-08-31
    • ABB TECHNOLOGY AGJUHLIN, Lars-Erik
    • JUHLIN, Lars-Erik
    • H02M7/48H02P13/12
    • H02M7/48H02M2007/4803H02P13/12
    • A method and a device are presented to compensate for an asymmetrical DC bias current in a multi-phase transformer, where the transformer is connected between an AC power system and an AC/DC or DC/AC high voltage converter. For each phase (R; S; T) of the AC side of the transformer a current quantity (I m ; I A ) is determined, where the current quantity reflects the time dependent behaviour of the magnetizing current in the phase, time intervals (R+; R-) in the current quantity are determined during which the current quantity reaches a positive or a negative maximum, respectively, a DC magnetizing quantity (Rin) is determined from a difference between the amplitude of the positive maximum and the amplitude of the negative maximum, an asymmetrical quantity (A R ) is determined from a difference between the amplitudes of the positive and/or negative maxima of at least two of the phases (R; S; T) and a control signal (DR; DS, DT) is generated from the asymmetrical quantity (A R ) and provided to a control device (16) of the converter in order to adjust the generation of the AC or DC voltage in the particular phase of the converter which corresponds to the phase (R; S; T) of the AC side of the transformer.
    • 提出了一种方法和装置,用于补偿多相变压器中的不对称直流偏置电流,其中变压器连接在交流电源系统和交流/直流或直流/交流高压变换器之间。 对于变压器的AC侧的每个相位(R; S; T),确定电流量(Im; IA),其中电流量反映相中的磁化电流的时间依赖性行为,时间间隔(R + 确定电流量的电流量分别为正或负最大值时的直流磁化量(Rin),根据正最大值的幅度与负最大值的振幅之差 根据至少两个相位(R; S; T)的正和/或负最大值的幅度之间的差确定非对称量(AR),并且产生控制信号(DR; DS,DT) (AR)并提供给转换器的控制装置(16),以便调整转换器的相应于相位(R; S; T)的特定相位中的AC或DC电压的产生, 的变压器的交流侧。
    • 4. 发明申请
    • VOLTAGE BALANCING OF SYMMETRIC HVDC MONOPOLE TRANSMISSION LINES AFTER EARTH FAULTS
    • 地震故障后对称HVDC单相传输线的电压平衡
    • WO2012055447A1
    • 2012-05-03
    • PCT/EP2010/066538
    • 2010-10-29
    • ABB TECHNOLOGY AGJUHLIN, Lars-Erik
    • JUHLIN, Lars-Erik
    • H02H7/12H02M1/32H02J3/36
    • H02J3/36H02H9/04H02M1/32Y02E60/60
    • A voltage balancing unit (330) for a symmetric monopole high voltage direct current (HVDC) transmission line (303) interconnecting two voltage source converters (VSCs) (301, 302), the transmission line comprising first arresters (321–324) having a first switching impulse protective level (SIPL), is provided. The voltage balancing unit comprises a pair of second arresters (331, 332) having a second SIPL which is less than the first SIPL, and switching means (333, 334) being arranged for temporarily connecting, in the event of a voltage unbalance on the transmission line, the first arresters between either pole (304, 305) and ground. The invention makes use of an understanding that a voltage unbalance on the transmission line may be removed by temporarily connecting second arresters, with a significantly lower SIPL than the first arresters, for limiting the pole voltage to a level close to the normal voltage. Further, a method of voltage balancing is provided. Voltage unbalances may arise as a consequence of lightning induced earth faults (311).
    • 一种用于互连两个电压源转换器(VSEM)(301,302)的对称单极高压直流(HVDC)传输线(303)的电压平衡单元(330),所述传输线包括第一避雷器(321-324) 提供了第一个开关脉冲保护电平(SIPL)。 电压平衡单元包括具有小于第一SIPL的第二SIPL的一对第二避雷器(331,332),以及切换装置(333,334),用于在电压不平衡的情况下临时连接 传输线,两极(304,305)和地之间的第一个避雷器。 本发明利用这样的理解可以通过临时连接第二避雷器来除去传输线上的电压不平衡,其中SIPL比第一避雷器明显更低,用于将极点电压限制在接近正常电压的水平。 此外,提供了电压平衡的方法。 由于雷电引起的接地故障,可能会导致电压不平衡(311)。
    • 6. 发明申请
    • METHOD AND ARRANGEMENT FOR DETECTING AND DAMPING TRANSIENT OSCILLATIONS AT OR NEAR A NATURAL RESONANT FREQUENCY IN A POWER TRANSMISSION SYSTEM
    • 用于检测和阻止瞬态振荡的方法和装置,其在电力传输系统中或接近于自然共振频率
    • WO1994007291A1
    • 1994-03-31
    • PCT/SE1993000747
    • 1993-09-15
    • ASEA BROWN BOVERI ABJUHLIN, Lars-Erik
    • ASEA BROWN BOVERI AB
    • H02J03/24
    • H02J3/24H02J3/36H02J2003/365Y02E60/60
    • An oscillation in a power transmission system is detected by multiplying voltage or current f(t) by a signal from an oscillator oscillating at a frequency at which oscillations are expected. The result is sampled with a frequency which exceeds the oscillator's, and the latest samplings which correspond to one or more entire periods of the frequency of the oscillator are successively summated. The successive summations are multiplied by the oscillator signal, whereby a regulating signal is obtained. By analysis of the said summations, a diagnosis is made as to whether damping correction is needed, and if this is the case, said regulating signal is connected to a regulating device to disconnect this when it is no longer required. The invention can be used both to eliminate oscillations in cables for high voltage direct current transmission and to eliminate subsynchronous oscillations in alternating current networks provided with gas and steam turbines.
    • 通过将电压或电流f(t)乘以来自振荡器预期频率振荡的振荡器的信号来检测电力传输系统中的振荡。 结果以超过振荡器的频率进行采样,并且对应于振荡器频率的一个或多个整个周期的最新采样被连续求和。 将连续相加乘以振荡器信号,从而获得调节信号。 通过对所述求和的分析,就是否需要进行阻尼校正进行诊断,如果是这种情况,则当不再需要时,所述调节信号连接到调节装置以断开连接。 本发明可以用于消除用于高压直流传输的电缆中的振荡并且消除具有气体和蒸汽涡轮机的交流网络中的次同步振荡。
    • 7. 发明申请
    • FAST BREAKER FAILURE DETECTION FOR HVDC CIRCUIT BREAKERS
    • 快速断路器故障检测用于高压直流断路器
    • WO2012136244A1
    • 2012-10-11
    • PCT/EP2011/055207
    • 2011-04-04
    • ABB TECHNOLOGY AGJUHLIN, Lars-Erik
    • JUHLIN, Lars-Erik
    • H02H7/30H02H7/26H02H7/22
    • H01H71/00H02H3/087H02H7/222H02H7/268
    • A breaker failure detection device for a direct current (DC) circuit breaker (200) is provided. The circuit breaker comprises a circuit breaking element (204) and a non-linear resistor, e.g., a surge arrester (205), connected in parallel. The breaker failure detection device comprises a current sensor (212, 213, 214, 215), for measuring a current commutating from the circuit breaking element (204), and a breaker failure detection unit (211). The breaker failure detection unit (211) is arranged for comparing the measured current to desired values and deciding that an internal commutation process of the circuit breaker (200) does not proceed as desired if the measured current deviates from the desired values. The present invention makes use of an understanding that an improved detection of breaker failures may be achieved by monitoring the internal commutation process of the circuit breaker. Further, a method of breaker failure detection is provided.
    • 提供一种用于直流(DC)断路器(200)的断路器故障检测装置。 断路器包括并联连接的断路元件(204)和非线性电阻器(例如避雷器(205))。 断路器故障检测装置包括用于测量从断路元件(204)换向的电流的电流传感器(212,213,214,215)和断路器故障检测单元(211)。 断路器故障检测单元(211)被布置成用于将测量的电流与期望值进行比较,并且如果测量的电流偏离期望值,则确定断路器(200)的内部换向过程不需要如期进行。 本发明利用这样的理解可以通过监视断路器的内部换向过程来实现对断路器故障的改进的检测。 此外,提供了一种断路器故障检测方法。
    • 8. 发明申请
    • POWER SUPPLY ARRANGEMENT FOR A SUBSTATION
    • 电源的电源装置
    • WO2012034593A1
    • 2012-03-22
    • PCT/EP2010/063615
    • 2010-09-16
    • ABB Technology AGJUHLIN, Lars-ErikASPLUND, Gunnar
    • JUHLIN, Lars-ErikASPLUND, Gunnar
    • H02J11/00H02M5/08
    • H02J11/00H02M5/08
    • The present invention concerns a power supply arrangement (18) for a substation, where this power supply arrangement comprises a group of reactive voltage dividing elements (20, 22, 24) connected to a first AC power line (10) that transports AC power to or from the substation and a first transformer (26) having a primary winding (PW) and a secondary winding (SW). The primary winding is connected in parallel with at least one (24) of the voltage dividing elements and the secondary winding is coupled to the substation for providing AC power for powering devices (36) of the substation. This arrangement allows cost savings in relation to transformers, especially at high voltages.
    • 本发明涉及一种用于变电站的电源装置(18),其中该电源装置包括连接到第一AC电力线(10)的一组无功分压元件(20,22,24),该第一AC电力线路将AC电力传送到 或来自变电站和具有初级绕组(PW)和次级绕组(SW)的第一变压器(26)。 初级绕组与至少一个(24)分压元件并联连接,次级绕组耦合到变电站,用于为变电站的设备(36)提供交流电力。 这种布置允许与变压器相关的成本节省,特别是在高压下。
    • 10. 发明申请
    • A CONVERTER STATION
    • 转换站
    • WO2007084035A8
    • 2008-05-22
    • PCT/SE2006000712
    • 2006-06-15
    • ABB TECHNOLOGY LTDRADBRANT ULFJUHLIN LARS-ERIK
    • RADBRANT ULFJUHLIN LARS-ERIK
    • H02J3/36H02H7/12H02H7/26
    • H02J3/36H02H3/05H02H7/26Y02E60/60Y10T307/653Y10T307/729
    • A converter station for connecting an AC system to a bipolar HVDC transmission line has a DC neutral arrangement provided with first DC breakers (131, 132) enabling breaking of a first current path from the neutral bus (112) of one pole (105) to the neutral bus (111 ) of the other pole (104) at bipolar operation of the station for changing to monopolar operation thereof for isolation of a faulty section of the system while establishing a current path to electrode line connecting members (142, 143) for diverting the current from said one pole (105) thereto. A separate connecting member (142, 143) is provided for each of the electrode lines (191, 192), and means are provided for connecting each neutral bus to an optional of the two electrode line connectin members.
    • 用于将AC系统连接到双极HVDC传输线的转换站具有直流中立装置,其具有第一直流断路器(131,132),其能够使从一个极(105)的中性总线(112)到第一电流路径 另一个极(104)的中性总线(111)在站的双极性操作下,用于改变到单极操作,以隔离系统的故障部分,同时建立到电极线连接构件(142,143)的电流路径,用于 将电流从所述一个极(105)转移到其上。 为每个电极线(191,192)提供单独的连接构件(142,143),并且提供用于将每个中性母线连接到两个电极线连接构件的任选的装置。