会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 5. 发明授权
    • Carrier stability erasure filling system for communications over
electricity distribution network
    • 载波稳定擦除填充系统,用于通信配电网络
    • US4996513A
    • 1991-02-26
    • US481247
    • 1990-02-20
    • Sioe T. MakRichard L. MaginnisKevin J. Franzen
    • Sioe T. MakRichard L. MaginnisKevin J. Franzen
    • H02J13/00
    • H02J13/0051Y02B90/263Y04S40/123
    • A communication system uses the current waveform of an electricity distribution network as a carrier, the signal being present as current pulses around four predetermined zero crossings. The current waveform is sampled around the voltage zero crossings to obtain a time-ordered set of waveform values. The ordered waveform values for each bit are examined to determine if the values fall within preset criteria indicative of a stable carrier. When the ordered waveform values for a particular bit all fall within the preset criteria, that particular bit is identified as a good bit. When at least some of the ordered waveform values for a particular bit fall outside the preset criteria, that particular bit is labelled as suspect. The ordered values of each suspect bit and of adjacent bits are tested to determine whether four successive values meets the preset stability criteria, and whether the four successive values indicating a stable carrier include at least two succesive values from the suspect bit. If the carrier stability test is passed, the binary value of the suspect bit is based upon the successive carrier stability indicating values from the suspect bit. Otherwise the suspect bit is labelled as uncorrectable.
    • 通信系统使用配电网络的电流波形作为载波,该信号作为围绕四个预定过零点的电流脉冲存在。 电流波形在电压过零点周围进行采样,以获得时间有序的波形值集合。 检查每个位的有序波形值,以确定值是否落在指示稳定载波的预设标准内。 当特定位的有序波形值全部落在预设标准内时,该特定位被识别为好位。 当特定位的有序波形值的至少一些值超出预设标准时,该特定位被标记为可疑。 测试每个可疑位和相邻位的有序值以确定四个连续值是否满足预设的稳定性标准,以及指示稳定载波的四个连续值是否包括来自可疑位的至少两个连续值。 如果载波稳定性测试通过,则可疑位的二进制值基于来自可疑位的连续载波稳定性指示值。 否则可疑位被标记为不可校正。
    • 6. 发明授权
    • Method and apparatus for remotely controlling an electrical appliance
    • 远程控制电器的方法和装置
    • US4329678A
    • 1982-05-11
    • US133559
    • 1980-03-24
    • Jerry M. Hatfield
    • Jerry M. Hatfield
    • G08B25/06H02J13/00H04L27/02H04B3/54
    • H04L27/02G08B25/06H02J13/0051Y10T307/944
    • A transmitter (12) has an output (13) adapted to be connected across an alternating current power line (AC1, AC2) at a point remote from an appliance (24) to be controlled. The transmitter generates one pulse per cycle of the alternating current. The pulse phase has a predetermined value with respect to the alternating current. A receiver (21) is adapted to be connected across the power line to couple the line to the appliance. When the receiver detects transmitter generated pulses during phase windows occurring each alternating current cycle, power is applied from the line to the appliance for the remainder of such alternating current cycle. The transmitter has an adjustment (14) that permits the phase of the transmitter generated pulses to be modulated and the receiver has an adjustment (26) that permits the position of the phase windows relative to the alternating current to be changed. The transmitter generated pulses and the phase windows occur only on every other half cycle of the alternating current. The transmitter includes a controlled rectifier which is fired on every other half cycle of the alternating current to generate the transmitter pulses; after firing, the controlled rectifier remains in a conducting state during the remainder of the alternating current half cycle.
    • 发射器(12)具有适于在远离被控制的器具(24)的点处跨过交流电力线(AC1,AC2)连接的输出端(13)。 发射机每个交流电循环产生一个脉冲。 脉冲相位相对于交流电流具有预定值。 接收器(21)适于跨越电力线连接以将线路耦合到器具。 当接收机在每个交流电周期发生的相窗期间检测到发射机产生的脉冲时,在这种交流周期的剩余时间内,从线路向器具施加功率。 发射机具有允许发射机产生的脉冲的相位被调制并且接收机具有允许相位相对于交流电的位置被改变的调整(26)的调节(14)。 发射机产生脉冲,相位窗只在交流电的每隔一个半周期出现。 发射机包括可控整流器,其在交流电的每隔一个半周期点火,以产生发射器脉冲; 在烧制之后,可控整流器在交流半周期的剩余时间期间保持导通状态。
    • 8. 发明授权
    • Power line data transmission system
    • 电力线数据传输系统
    • US3938129A
    • 1976-02-10
    • US499363
    • 1974-08-21
    • Miles A. Smither
    • Miles A. Smither
    • E21B47/12H02J13/00H04B3/54H04M11/04
    • H02J13/0051E21B47/12H04B3/542H04B2203/5416H04B2203/542H04B2203/5475H04B2203/5495
    • A power line data transmission system is disclosed in which data is transmitted over a line carrying alternating current power by varying or modulating the power factor of the line or the phase angle of the power on the line in accordance with a signal to be transmitted. A series connected reactance and switch are connected across the line. The switch is turned on and off in response to the data signal to be transmitted over the line. The phase angle of the voltage and current on the line is detected at the receiving location. The phase relation between the voltage and the current is detected or compared to produce a binary digital signal corresponding to the data sent over the line. The detection of the voltage and current being out of phase by a predetermined amount may be used to generate a signal indicating a digital one. The detection of the voltage and current being in phase may be used to generate a signal corresponding to a digital zero.
    • 公开了一种电力线数据传输系统,其中通过根据要发送的信号改变或调制线路的功率因数或线路上的功率的相位角,通过承载交流电力的线路传输数据。 串联的电抗和开关连接在一起。 响应于要在线路上传输的数据信号,开关被打开和关闭。 在接收位置检测线路上的电压和电流的相位角。 检测或比较电压和电流之间的相位关系,以产生对应于通过线路发送的数据的二进制数字信号。 电压和电流异相检测预定量可以用于产生指示数字信号的信号。 可以使用同相的电压和电流的检测来产生对应于数字零的信号。