会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Reduced corrosion electronic descaling technology
    • 减少腐蚀电除垢技术
    • US5670041A
    • 1997-09-23
    • US544026
    • 1995-10-17
    • Young I. ChoKarl M. Kyriss
    • Young I. ChoKarl M. Kyriss
    • C02F1/48
    • C02F1/487C02F2201/483C02F2303/22Y10S138/06
    • A method for minimizing localized corrosion of fluid containers that occurs as a consequence of most non-chemical procedures for removing scale deposits is described. It counteracts the unavoidable side-effect of the lowering of the local pH in the vicinity of the bubbles of CO.sub.2 that are generated during an electromagnetically-induced controlled precipitation procedure. The method is a simple and facile procedure for curbing the localized corrosion occurring as a result of most non-chemical procedures for removing scales. The method is desirably performed by an induction coil wrapped around a fluid container such as a pipe encrusted with scale through which hard water is flowing. A pulsing electrical current is successively applied through the coil and halted, preferably for 3 to 10 minutes each. When the current is applied, a transitory induced magnetic field is generated in the solution, and scale encrusted on the fluid container dissolves in the solution. When the pulsing current is stopped, the induced magnetic field in the solution ceases and so the scale stops dissolving, allowing a protective layer of scale to form over potential points of corrosion. Optionally permanent magnets may be used in the process, alone or with an induction coil.
    • 描述了一种用于最小化流体容器的局部腐蚀的方法,这种腐蚀是大多数用于去除垢垢的非化学过程的结果。 它抵消了在电磁感应控制沉淀过程中产生的CO 2气泡附近局部pH降低的不可避免的副作用。 该方法是用于抑制由于大多数非化学程序去除垢而导致的局部腐蚀的简单和容易的程序。 该方法期望地通过缠绕在流体容器上的感应线圈来实现,该流体容器例如是包裹有硬质水流过的水垢的管道。 脉冲电流依次通过线圈施加并停止,优选为3至10分钟。 当施加电流时,在溶液中产生瞬时感应磁场,并且结垢在流体容器上的刻度溶解在溶液中。 当脉冲电流停止时,溶液中的感应磁场停止,因此刻度停止溶解,允许保护层形成超过潜在的腐蚀点。 可选地,永磁体可以在该过程中单独使用或与感应线圈一起使用。
    • 2. 发明授权
    • Sampling device for determining conditions on the interior surface of a
water main
    • 用于确定水主体内表面状况的取样装置
    • US4631961A
    • 1986-12-30
    • US815407
    • 1985-12-31
    • Thomas L. YoheRodney M. DonlanKarl M. Kyriss
    • Thomas L. YoheRodney M. DonlanKarl M. Kyriss
    • G01N17/00
    • G01N17/00
    • A probe rod is inserted into a water main through a corporation cock. The rod has a plurality of transverse passages parallel to one another and aligned in the direction of flow. Within these transverse passages, in flush relationship to the passage walls, are inserted removable sampling rings. All but one of the rings are of the same material as the inner wall of the main. The remaining ring, used as a control, is a synthetic resin ring. The flush relationship prevents the formation of turbulent eddies at the ends of the rings. Consequently, microbial growth conditions on the rings themselves reliably simulate conditions on the interior wall of the main.Within a tubular extension on the exterior of the corporation cock an O-ring seal is provided. The length of the extension, and the position of the seal, are such that the probe rod can be partially withdrawn beyond the corporation valve without causing any of the transverse passages to pass through the O-ring. Thus, the rod can be partially withdrawn, and the corporation valve closed before the rod is fully withdrawn. Because of the length of the extension and the position of the O-ring, partial withdrawal of the probe rod can be accomplished without scouring of the sampling rings due to high velocity flow of water through the transverse passages as they move through the O-ring.
    • 探针杆通过公司公鸡插入水中。 杆具有彼此平行并沿着流动方向对准的多个横向通道。 在与通道壁平齐的这些横向通道内插入可移除的取样环。 除了一个环之外,所有的环都是与主体的内壁相同的材料。 用作对照的剩余环是合成树脂环。 冲洗关系防止在环的端部形成湍流涡流。 因此,环上的微生物生长条件本身可靠地模拟主体内壁上的状况。 在公司外壳的管状延伸部内设有O形密封圈。 延伸部的长度和密封件的位置使得探针杆可以部分地从公司阀外部抽出,而不会使任何横向通道穿过O形环。 因此,杆可以部分地撤回,并且在杆被完全拉出之前公司阀关闭。 由于O形环的延伸长度和位置,探针棒的部分抽出可以在水通过O形环时通过横向通道的高速流动导致取样环的冲刷而实现。 。