会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Electro static discharge protection for processing active matrix liquid
crystal displays
    • 用于处理有源矩阵液晶显示器的静电放电保护
    • US5353142A
    • 1994-10-04
    • US55047
    • 1993-04-29
    • Sonia R. Dodd
    • Sonia R. Dodd
    • G02F1/13G02F1/1362G02F1/1343
    • G02F1/133308G02F1/136204G02F2001/133334
    • An improved method for providing extended electro static discharge protection of an active matrix liquid crystal display, at the external lead contact areas by using a shorting conductor or bar to short out all row and column contacts or leads on the display, and to protect the electronics during active matrix processing, fabrication, polarizer attachment, and connecting of display leads. The display connection leads and the shorting bar on those leads, are on the front side of the active glass layer of the display. A saw is used to provide an accurate and relatively deep cut on the back side of the active glass layer thereby forming a border within the perimeter of the shorting bar on the front side of the active glass layer. The cut on the back side does not go through the active glass layer but stops several mils from the front side of the active glass layer. This method allows the shorting bar to remain intact with the display's external leads through all of the processing steps, including polarizer installation and the flex connector/driver connection, at least until active matrix liquid crystal display testing is ready to commence. After the polarizers are attached and external connections to the display contacts are made, the edge or border of the active glass layer, incorporating the shorting bar, is broken off at the cut.
    • 一种改进的方法,用于通过使用短路导体或条来在有源矩阵液晶显示器的外部引线接触区域提供延长的静电放电保护,以缩短显示器上的所有行和列触点或引线,并保护电子元件 在有源矩阵处理,制造,偏振器附着和显示引线的连接。 显示器连接引线和这些引线上的短路棒位于显示屏的有源玻璃层的正面。 锯用于在活性玻璃层的背面提供精确且相对较深的切割,从而在活性玻璃层的前侧上的短路棒的周边内形成边界。 背面的切割不通过活性玻璃层,而是从活性玻璃层的前侧停止数个密耳。 这种方法允许短路棒保持完整,显示器的外部引线通过所有处理步骤,包括偏振器安装和柔性连接器/驱动器连接,至少直到有源矩阵液晶显示测试准备开始。 在安装偏振器并且与显示触点进行外部连接之后,包括短路棒的活性玻璃层的边缘或边界在切割处被断开。