会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 65. 发明授权
    • Lamp starting and operating procedure in electronic ballast
    • 电子镇流器灯启动和运行程序
    • US5103139A
    • 1992-04-07
    • US497311
    • 1990-03-22
    • Ole K. Nilssen
    • Ole K. Nilssen
    • H02M1/00H02M1/42H02M7/5383H05B41/28
    • H02M1/425H02M7/53832H05B41/28Y02B70/126
    • In a power-line-operated power-factor-corrected electronic ballast, a pair of series-connected fluorescent lamps is powered via a tuned L-C circuit that is series-excited by the rectangular-wave 33 kHz voltage output of a half-bridge inverter and parallel-loaded by the fluorescent lamps. Power factor correction is attained via two energy-storing capacitors charged during periods when the instantaneous absolute magnitude of the power line voltage exceeds half of its peak absolute magnitude and discharged when it fails to exceed half of this peak absolute magnitude. As a result, a so-called valley-filled DC voltage is provided to the inverter; which results in the inverter's rectangular-wave output voltage being about 50% amplitude-modulated. In spite of this high degree of amplitude-modulation, the resulting lamp current crest factor is only about 1.8. By control of the symmetry of the inverter's rectangular-wave output voltage, the fluorescent lamp is started and operated in such a manner that maximum available ballast output current is limited to about 30 milli-Ampere (which magnitude of 33 kHz current is considered safe from electric shock hazard) until such time as verification is provided to the effect that this 30 milli-Ampere of 33 kHz current is indeed flowing through both lamps (as opposed to through a ground loop); whereafter the symmetry of the rectangular-wave output voltage is re-controlled such as to provide for the lamp current to increase to some preset level.
    • 在电力线操作的功率因数校正电子镇流器中,一对串联荧光灯通过调谐LC电路供电,该LC电路由半桥逆变器的矩形波33 kHz电压输出串联激励 并由荧光灯并行加载。 在电力线电压的瞬时绝对幅度超过其峰值绝对值的一半的期间,通过两个储能电容器充电来实现功率因数校正,并且当其不能超过绝对峰值的一半时放电。 结果,向逆变器提供所谓的谷底直流电压; 这导致逆变器的矩形波输出电压幅度约为50%。 尽管这种高度的幅度调制,所得的灯电流波峰因数仅为约1.8。 通过控制逆变器矩形波输出电压的对称性,荧光灯以这样的方式启动并运行,使得最大可用镇流器输出电流被限制为大约30毫安(这个33kHz电流的大小被认为是安全的 直到提供验证的时间,以确保这个30毫安的33 kHz电流确实流过两个灯(与通过接地回路相反); 此后,矩形波输出电压的对称性被重新控制,以便提供灯电流增加到一些预设电平。
    • 66. 发明授权
    • Series-connected power-line controller
    • 串联电源线控制器
    • US5032782A
    • 1991-07-16
    • US419259
    • 1989-10-10
    • Ole K. Nilssen
    • Ole K. Nilssen
    • H02M1/00H02M1/42H05B41/392
    • H02M1/425H05B41/3927Y02B70/126
    • A full-bridge transistor inverter is connected at its DC supply-side with an energy-storing capacitor. The inverter's output terminals are connected in series between a source of AC voltage and a load; which load may be an electric motor, a fluorescent lighting system, etc. By controllably switching the transistors of the inverter ON and OFF at some rate higher than, but basically synchronous with, the frequency of the AC voltage, effective control of the flow of power between the AC source and the load is achieved. DC voltage on the energy-storing capacitor is obtained from the AC source and established by way of the timing of the switching action of the inverter.Hence, in contrast with the ordinary situation where an inverter is supplied with net power from its source of DC voltage and where this net power is then supplied to a load connected with the inverter's output, the present invention relates to a situation where generally no net power is supplied to the inverter from its source of DC voltage and where generally no net power is supplied from the inverter's output. Instead, the inverter is used for controlling the waveform, magnitude and phasing of the alternating current flowing through it by way of its output terminals.
    • 全桥晶体管逆变器在其直流电源侧连接有储能电容器。 变频器的输出端子串联连接在交流电源和负载之间; 哪个负载可以是电动机,荧光照明系统等。通过以与交流电压的频率高于但基本上同步的一些速率可控地切换逆变器的晶体管的开和关,有效地控制 实现了交流电源和负载之间的电源。 蓄电电容器上的直流电压由交流电源获得,并通过逆变器开关动作的定时来建立。 因此,与逆变器从其直流电压源提供净功率并且然后将该净功率提供给与逆变器的输出相连接的负载的普通情况相反,本发明涉及一般情况下, 电源从其直流电压源提供给逆变器,并且其中通常没有从逆变器的输出提供净功率。 相反,逆变器用于控制通过其输出端子流过它的交流电流的波形,幅度和相位。
    • 67. 发明授权
    • Power factor correction in electronic ballasts
    • 电子镇流器的功率因数校正
    • US5001400A
    • 1991-03-19
    • US486930
    • 1990-03-01
    • Ole K. Nilssen
    • Ole K. Nilssen
    • H02M1/00H02M1/42H05B41/28
    • H02M1/425H05B41/28Y02B70/126Y10S315/05
    • In a power-line-operated electronic ballast for a gas discharge lamp, an inverter converts a DC supply voltage to a high frequency current-limited operating voltage for a fluorescent lamp. The DC voltage is obtained, at least in part, by forward inductive-discharge conversion of full-wave-rectified unfiltered power line voltage; which forward conversion is accomplished by high frequency switching of an energy-storing inductor; the switching being done by the very same inverter that provides the high frequency lamp operating voltage. As an overall result, power is drawn from the power line with a power factor higher than 98% and with a total harmonic distortion under 10%.
    • 在用于气体放电灯的电力线操作的电子镇流器中,逆变器将DC电源电压转换成用于荧光灯的高频限流工作电压。 直流电压至少部分地通过全波整流的未滤波电力线电压的正向感应放电转换获得; 该正向转换通过储能电感器的高频切换来实现; 该切换由提供高频灯工作电压的相同逆变器完成。 总体而言,功率因数高于98%,总谐波失真为10%以下的电力线。