会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 7. 发明专利
    • Subscriber circuit
    • 订户电路
    • JPS61113348A
    • 1986-05-31
    • JP23445884
    • 1984-11-07
    • Fujitsu LtdHitachi LtdNec CorpNippon Telegr & Teleph Corp Oki Electric Ind Co Ltd
    • SHINKAWA HIROSHIKOINUMA TAKEOMURAKAMI SUEOONO MASAHIKOIRIBE SHINICHI
    • H04M19/00H04M3/02H04M3/06H04Q3/42
    • PURPOSE: To ensure non-ringing calling by disconnecting a capacitor from a feedback path and connecting it to the feedback path after polarity inversion while a switch is being interrupted in a digital exchange.
      CONSTITUTION: In closing a switch 22 for non-ringing call to a telemeter terminal device 24, a load current IL is fed from a feeding circuit 15. Then in zeroing a voltage V
      ab to stop the supply of the load current IL, since the capacitor 14 is connected to the feedback circuit via a diode 26 and a resistor 5, the load current IL is not controlled. Further, in inputting a non-ringing call signal NRS to a current mirror 11 while being superimposed on the control current I1 for polarity inversion, no discharge current except a current I3 is inputted to a current mirror 10, the prescribed control current I1 is outputted and the non-ringing signal is received immediately.
      COPYRIGHT: (C)1986,JPO&Japio
    • 目的:通过在数字交换机中断交换机的极性反转之后,断开电容器与反馈路径的连接,并将其连接到反馈路径,确保无振铃呼叫。 构成:在关闭用于非电话呼叫到遥测仪终端装置24的开关22时,从馈电电路15馈送负载电流IL。然后,在使电压Vab置零以停止负载电流IL的供应,因为电容器 14通过二极管26和电阻器5连接到反馈电路,不控制负载电流IL。 此外,在将非振铃呼叫信号NRS与用于极性反转的控制电流I1重叠的同时向电流镜11输入时,除电流I 3以外的放电电流不被输入到电流镜10,输出规定的控制电流I1 并且立即接收非振铃信号。
    • 8. 发明专利
    • Terminal control system
    • 终端控制系统
    • JPS59161198A
    • 1984-09-11
    • JP3458083
    • 1983-03-04
    • Hitachi LtdNippon Telegr & Teleph Corp Oki Electric Ind Co Ltd
    • IRIBE SHINICHIKOINUMA TAKEONANBA SHINJI
    • H04Q3/42H04Q1/38
    • H04Q1/38
    • PURPOSE:To send out a current inverting signal to a no-ringing terminal by a simple circuit, and to prevent a bell from ringing by discharging all charges accumulated in a capacity of a telephone set to a dummy loop, and subsequently, inverting a current direction and executing the charging. CONSTITUTION:When the contact 301 of a dummy loop forming relay is closed, an impression voltage to a telephone set 102 drops. Subsequently, a cutting relay of a current supplying relay 106 is operated, and its contacts 305, 306 are opened to discharge a capacity of the telephone set 102 completely by a dummy loop resistance 302 and high resistance elements 303, 304. Subsequently, the current is inverted by the contacts 104, 105 of a current inverting relay, and simultaneously, the contact 301 is opened, and the capacity of the telephone set 102 is charged through the elements 303, 304.
    • 目的:通过简单的电路将电流反相信号发送到无振铃端子,并且通过将在电话机的容量中累积的所有电荷放电到虚拟环路来防止振铃,并且随后将电流反转 方向并执行充电。 构成:当虚拟环形继电器的触点301闭合时,电话机102的压印电压下降。 随后,电流供应继电器106的切断继电器被操作,并且其触点305,306被打开以通过虚拟回路电阻302和高电阻元件303,304完全释放电话机102的容量。随后,电流 由电流反相继电器的触点104,105反转,同时触点301断开,电话机102的容量通过元件303,304充电。
    • 10. 发明专利
    • GYRATOR
    • JPS5864817A
    • 1983-04-18
    • JP16345881
    • 1981-10-15
    • OKI ELECTRIC IND CO LTDNIPPON TELEGRAPH & TELEPHONE
    • KOMAZAKI TOMOKAZUNANBA SHINJIKOINUMA TAKEO
    • H03H11/42H03H11/50
    • PURPOSE:To set the capacitance of a capacitor small and to increase the Q of an equivalent inductance, by using a resistor and a capacitor for each admittance of a gyrator circuit as specified. CONSTITUTION:Y4-Y8 are admittances of each element, 1-3 are nodes of this circuit, and V2, V3 are voltages at nodes 2 and 3 respectively. The relation between input terminals Vin and V2 of input terminals 1a, 1b and an output Vout of an operational amplifier 4 is expressed in equations 1 and 2. Thus, an input impedance Zin is expressed in equation 3. Where Y5Y7=Y6Y8 is satisfied, equation 3 is simplified into equation 4. Taking Y4=SC, Y5=1/R5 and Y8=1(that is, resistors R5, R8 are used for Y5, Y8 respectively and a capacitor C is used for Y4) in equation 4, a series circuit of R and L is obtained as given by equation 5. In equation 5, the resisters R5, R8 are included in the imaginary part and the capacitance value of the capacitor C can be set arbitrarily independently of the Q of the equivalent inductance to some extent. Thus, said Q can be increased.