会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 6. 发明授权
    • T/R first and second intervals for strobes and data packets
    • 用于选通和数据包的T / R第一和第二间隔
    • US09001870B2
    • 2015-04-07
    • US13491982
    • 2012-06-08
    • Sandeep BhadraSoon-Hyeok ChoiXiaolin Lu
    • Sandeep BhadraSoon-Hyeok ChoiXiaolin Lu
    • H04B1/38H04W52/02H04W40/24
    • H04W52/0229H04W40/246H04W52/0238Y02D70/00Y02D70/144Y02D70/22
    • The duration of receiver on-times may be minimized by sensing and reacting to communication channel power levels at intervals. When no energy is detected on the communication channel, then the receiver may be turned off for a channel sampling interval. If energy is detected on the channel, then the receiver may remain on to determine if a received message is associated with the device. Receiver on-time may also be minimized by adjusting the timing of messages used for broadcast messages sent by routing or other protocols. Broadcast messages, such as network routing topology messages, may be controlled in two phases. In a first phase, the broadcast messages are sent with at a high rate to allow nodes to join the network rapidly. In a second phase, the broadcast messages are sent with at a lower rate to minimize interference with data and other messages in the network.
    • 接收器接通时间的持续时间可以通过以间隔感测和响应通信信道功率电平来最小化。 当在通信信道上没有检测到能量时,接收机可以被关闭以用于信道采样间隔。 如果在信道上检测到能量,则接收机可以保持接通,以确定接收到的消息是否与设备相关联。 通过调整用于由路由或其他协议发送的广播消息的消息的定时,接收器接通时间也可以被最小化。 诸如网络路由拓扑消息之类的广播消息可以分两个阶段进行控制。 在第一阶段,以高速发送广播消息,以允许节点快速加入网络。 在第二阶段中,以较低的速率发送广播消息以最小化对网络中的数据和其他消息的干扰。
    • 8. 发明申请
    • Dynamic Power Management in Real Time Systems
    • 实时系统中的动态电源管理
    • US20130198540A1
    • 2013-08-01
    • US13363949
    • 2012-02-01
    • Sejoong LeeSoon-Hyeok ChoiXiaolin Lu
    • Sejoong LeeSoon-Hyeok ChoiXiaolin Lu
    • G06F1/32
    • G06F1/32G06F1/3206G06F1/3243G06F9/48G06F11/34Y02D10/152Y02D50/20
    • Dynamically reducing power consumption by a processor in a computer system by determining a maximum number of times (token count) that the processor can incur a start-up delay after being placed into a low-power mode during a token period of time when executing a task for a token period of time. The processor may be placed into the low-power mode while executing the task in response to an idle indicator only if a current value of the token count assigned to the task is greater than zero. The current value of the token count is decremented each time the processor incurs a start-up delay in response to being awakened from the low-power mode. The current token count is reset to match the assigned token count at the end of each token period. Furthermore, wakeup may be anticipated to allow the processor to be awakened preemptively.
    • 在计算机系统中通过确定处理器在执行一个令牌周期之后放入低功率模式之后可以引起启动延迟的最大次数(令牌计数)来动态地减少计算机系统中的处理器的功率消耗 任务为令牌的一段时间。 只有当分配给任务的令牌计数的当前值大于0时,处理器才可以响应于空闲指示符而执行任务而被置于低功率模式。 每当处理器响应于从低功率模式唤醒而引起启动延迟时,令牌计数的当前值递减。 当前令牌计数被重置为与每个令牌周期结束时分配的令牌计数相匹配。 此外,可以预期唤醒以允许处理器被抢先地唤醒。
    • 9. 发明申请
    • Radio Duty Cycle Minimization Techniques for Transmission-Initiated Wireless Multi-Hop Networks
    • 用于传输发起的无线多跳网络的无线电占空比最小化技术
    • US20120314739A1
    • 2012-12-13
    • US13491982
    • 2012-06-08
    • Sandeep BhadraSoon-Hyeok ChoiXiaolin Lu
    • Sandeep BhadraSoon-Hyeok ChoiXiaolin Lu
    • H04B1/38
    • H04W52/0229H04W40/246H04W52/0238Y02D70/00Y02D70/144Y02D70/22
    • The duration of receiver on-times may be minimized by sensing and reacting to communication channel power levels at intervals. When no energy is detected on the communication channel, then the receiver may be turned off for a channel sampling interval. If energy is detected on the channel, then the receiver may remain on to determine if a received message is associated with the device. Receiver on-time may also be minimized by adjusting the timing of messages used for broadcast messages sent by routing or other protocols. Broadcast messages, such as network routing topology messages, may be controlled in two phases. In a first phase, the broadcast messages are sent with at a high rate to allow nodes to join the network rapidly. In a second phase, the broadcast messages are sent with at a lower rate to minimize interference with data and other messages in the network.
    • 接收器接通时间的持续时间可以通过以间隔感测和响应通信信道功率电平来最小化。 当在通信信道上没有检测到能量时,接收机可以被关闭以用于信道采样间隔。 如果在信道上检测到能量,则接收机可以保持接通,以确定接收到的消息是否与设备相关联。 通过调整用于由路由或其他协议发送的广播消息的消息的定时,接收器接通时间也可以被最小化。 诸如网络路由拓扑消息之类的广播消息可以分两个阶段进行控制。 在第一阶段,以高速发送广播消息,以允许节点快速加入网络。 在第二阶段中,以较低的速率发送广播消息以最小化对网络中的数据和其他消息的干扰。