会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 7. 发明专利
    • Gas blocking control apparatus
    • 气体阻塞控制装置
    • JPS61137038A
    • 1986-06-24
    • JP25740084
    • 1984-12-07
    • Fuji Electric Co LtdFuji Facom Corp
    • IIJIMA TERUAKIFUKUDA TOKUYUKI
    • F16K17/36G01M3/00G01M3/04G01M3/28G08B21/00G08B21/16
    • G01M3/2876
    • PURPOSE:To reduce the number of blocking times while attaining safety, by changing the time reaching the blocking of gas from a time, when an accident of gas from a time, when an accident was generated, corresponding to a time zone and the flow amount of supplied gas when the blocking of gas is performed on the basis of a gas leakage detection signal. CONSTITUTION:When gas leakage is generated in a gas instrument 3, a gas leakage detector 1 is operated to send out gas leakage information to an operation circuit 23. Because gas flow amount information is always sent to the operation circuit 23 from a flowmeter 5, the time for blocking gas is operated from the gas flow amount information and time information to perform the setting of the time of a timer 24. The timer 24 applies gas blocking information to blocking valve 4 after the set time was elapsed. At this time, because the operation circuit 23 monitors the time information from a clock circuit 25, said circuit 23 performes different operation corresponding to a time zone.
    • 目的:为了在达到安全的同时减少堵塞次数,通过改变从一段时间到达气体阻塞的时间,当发生事故时,发生事故时,对应于时间段和流量 基于气体泄漏检测信号进行气体阻断时的供给气体。 构成:在气体仪器3中产生气体泄漏的情况下,操作气体泄漏检测器1,将气体泄漏信息发送到运转电路23.由于气流量信息总是从流量计5发送到运算电路23, 根据气体流量信息和时间信息来操作阻塞气体的时间,以执行定时器24的时间的设定。定时器24在经过设定时间之后对阻塞阀4施加气体阻塞信息。 此时,由于运算电路23监视来自时钟电路25的时间信息,所以电路23对时间段进行不同的动作。
    • 8. 发明专利
    • GAS LEAK ALARM
    • JPH052006A
    • 1993-01-08
    • JP11892991
    • 1991-05-24
    • FUJI ELECTRIC CO LTD
    • FUKUDA TOKUYUKINAKAMURA TSUKASAICHIJIMA MASAAKIUCHIKI TAKASHIOCHIWA SHINICHINAGASE NORIYOSHI
    • G01N27/12
    • PURPOSE:To shorten the initial alarm time by constituting a detecting part of a stress sensitive body of a metallic oxide semiconductor, a pair of electrodes for measuring the resistance change of the sensitive body, and a heater for heating the sensitive body on a substrate, and forming a load circuit of at least a positive characteristic thermistor as a load to the sensitive body. CONSTITUTION:This gas leak alarm has a detecting part and a load circuit. In the detecting part 1, a stress sensitive body 6 made of a metallic oxide semiconductor, a pair of electrodes for measuring the resistance change of the sensitive body 6, and a heater 5 for heating the sensitive body 6 are provided on a substrate. Meanwhile, the load circuit is comprised of at least a positive temperature coefficient thermistor 15 as a load to the sensitive body. A response characteristic 23 of the thermistor 15 and the characteristic 22 of the sensitive body assume approximate curves to each a set resistance value RA. The initial alarm time of the sensitive body 6 of this gas leak alarm is shortened to 1/3 displayed by a characteristic 21 of a conventional sensitive body. Since the resistance value of the sensitive body 6 is a small value approximate to the resistance value of the thermistor 15 before it reaches the set resistance value RA, the sensitive body 6 generates heat with consuming a large amount of power and reaches the set resistance value RA quickly.
    • 10. 发明专利
    • Delay circuit
    • 延时电路
    • JPS54149564A
    • 1979-11-22
    • JP5846578
    • 1978-05-17
    • Fuji Electric Co Ltd
    • SAKURAI KAZUOFUKUDA TOKUYUKIKANO SHIYUNSUKE
    • H03K17/22H03K17/292
    • H03K17/292
    • PURPOSE:To make it possible to prevent unneeded long-period operation due to initial error information even if the delay time is short, by allowing a circuit not to operate for mixed time at the time of power feeding by using a smoothing capacitor and diodes. CONSTITUTION:When the power supply is put to work, no Zener currents flows from Zener diode ZD1 to diode D2 until the charging voltage of smoothing capacitor C3 reaches the Zener voltage. The time depends upon resistance R1 and the time constant of capacitor C3. If an input signal is gemerated at input-signal secondary winding T2 in this state, the signal current is cut off by diode D2, so that a charging voltage of the polarity applying a reverse bias between the base and emitter of transistor Tr1 will never be developed in capacitor C1. Transistor Tr1, therefore, remains conductive and capacitor C2 is not charged, so that the delay circuit will never operate. When the charging voltage of capacitor C3 reaches the Zener voltage of Zener diode ZD1 afterwards, the delay operation starts.
    • 目的:即使延迟时间短,也可以通过使用平滑电容器和二极管使供电时的电路不工作在混合时间,从而可以防止由于初始误差信息引起的不必要的长时间操作。 构成:当电源工作时,平稳电容器C3的充电电压达到齐纳电压之前,齐纳二极管ZD1不会流过二极管D2。 时间取决于电阻R1和电容器C3的时间常数。 在这种状态下,如果在输入信号次级绕组T2输入信号,则信号电流被二极管D2截止,从而在晶体管Tr1的基极和发射极之间施加反向偏置的极性的充电电压将永远不会 在电容器C1中开发。 因此,晶体管Tr1保持导通,电容器C2未充电,因此延迟电路将永远不会工作。 当电容器C3的充电电压到达齐纳二极管ZD1的齐纳电压后,延迟操作开始。