会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 2. 发明授权
    • Field sensor communication system
    • 现场传感器通讯系统
    • US5469156A
    • 1995-11-21
    • US877137
    • 1992-05-01
    • Makoto Kogure
    • Makoto Kogure
    • G08C19/02G08C25/00H04B3/50H04B3/54
    • G08C19/02
    • A field sensor communication system is arranged in such a manner that, when an electric current, the level of which can be changed to a predetermined level, is, transmitted to a signal transmission line having at least one load resistor connected in series and the voltage change across the load resistor due to the change in the electric current is detected as a reception signal, the predetermined level is cyclically changed to a plurality of levels so that the level at which a good signal reception condition can be realized is determined to perform a communication at the thus determined level. As a result, even if the value of the load resistor in the signal transmission line is changed, the communication can be performed normally, since an undesirable change of the level of the reception signal can be prevented.
    • 现场传感器通信系统被布置成使得当其电平可以改变到预定电平的电流被传送到具有串联连接的至少一个负载电阻器的信号传输线路时,电压 作为接收信号检测由于电流变化而在负载电阻上的变化,将预定电平循环变化为多个电平,从而确定能够实现良好的信号接收条件的电平,以执行 通信在如此确定的水平。 结果,即使信号传输线中的负载电阻器的值改变,由于可以防止接收信号的电平的不期望的改变,所以可以正常地进行通信。
    • 6. 发明授权
    • Field sensor communication method and system
    • 现场传感器通信方法与系统
    • US5184121A
    • 1993-02-02
    • US487124
    • 1990-03-02
    • Makoto KogureAkira SaseMasao Fukunaga
    • Makoto KogureAkira SaseMasao Fukunaga
    • G08C25/02G08C19/02
    • G08C19/02
    • In a communication system in which a plurality of communication units are connected to a common two-wire transmission line and signal transmission/reception is made between the communication unit and a field sensor connected to one end of the transmission line, the communication unit transmits a signal to the field sensor under the condition that no signal is present on the transmission line during a period of time not shorter than a predetermined time while the field sensor transmits a signal indicative of in-use of the transmission line at an interval of time shorter than the predetermined time during a period of time until the field sensor sends back a signal in response to the signal from the communication unit, whereby signal collision between the plurality of communication units is prevented with no provision of any specific means.
    • 在其中多个通信单元连接到公共双线传输线并且在通信单元和连接到传输线的一端的场传感器之间进行信号发送/接收的通信系统中,通信单元发送 在场传感器以更短的时间间隔发送指示传输线的使用信号的信号的情况下,在不短于预定时间的时间段内,在传输线路上不存在信号的情况下,向场传感器发信号 比直到现场传感器响应于来自通信单元的信号发回信号的时间段内的预定时间为止,从而防止了多个通信单元之间的信号冲突,而没有提供任何特定的方式。
    • 7. 发明授权
    • Distributed control system and filtering method used in the distributed control system
    • 分布式控制系统和分布式控制系统中使用的过滤方法
    • US06957109B2
    • 2005-10-18
    • US10625623
    • 2003-07-24
    • Masahiro OhashiTakeiki AizonoDai FujiiHiroyuki TanakaMakoto Kogure
    • Masahiro OhashiTakeiki AizonoDai FujiiHiroyuki TanakaMakoto Kogure
    • G06F15/16G05B15/02H04L29/06H04L29/08G06B19/18
    • H04L29/06C04B2237/366H04L67/12
    • In a distributed control system in which a plurality of nodes are connected to a transmission line, each node controlling components connected to this node and transmitting a message to other nodes, a message sent by each node includes at least two message-sending condition-identifying portions, one of the condition-identifying portions including data indicating a message-receiving node or non-designation of a message-receiving node; and a comparison-selection circuit provided in each node includes registration parts for registering data of message-receiving conditions, at least two registration parts for comparing contents of the condition-identifying portion in the taken-in message with the data of message-receiving conditions registered in the registration parts, a received-message storing part for storing a message to be received in this node, a control part for determining whether or not the taken-in message is to be received in this node based on a result of comparison-processing performed in the comparison and selection means and for transferring the taken-in message to the received-message storing part if it is determined that the taken-in message is received in this node, otherwise, abandoning the taken-in message.
    • 在其中多个节点连接到传输线的分布式控制系统中,每个节点控制连接到该节点的组件并向其他节点发送消息,由每个节点发送的消息包括至少两个消息发送条件识别 条件识别部分中的一个包括指示消息接收节点的数据或消息接收节点的非指定; 并且在每个节点中提供的比较选择电路包括用于登记消息接收条件的数据的登记部分,用于将所述接收消息中的条件识别部分的内容与消息接收条件的数据进行比较的至少两个注册部分 登记在所述登记部分中,接收消息存储部分,用于存储要在该节点中接收的消息;控制部分,用于基于比较结果确定是否在该节点中接收到所接收的消息; 在比较和选择装置中执行的处理,并且如果确定在该节点中接收到接收消息,则将接收消息传送到接收消息存储部分,否则放弃接收消息。
    • 8. 发明授权
    • Distributed control system and filtering method used in the distributed control system
    • 分布式控制系统和分布式控制系统中使用的过滤方法
    • US06708069B2
    • 2004-03-16
    • US10158083
    • 2002-05-31
    • Masahiro OhashiTakeiki AizonoDai FujiiHiroyuki TanakaMakoto Kogure
    • Masahiro OhashiTakeiki AizonoDai FujiiHiroyuki TanakaMakoto Kogure
    • G05B1302
    • H04L29/06C04B2237/366H04L67/12
    • In a distributed control system in which a plurality of nodes are connected to a transmission line, each node controlling components connected to this node and transmitting a message to other nodes, a message sent by each node includes at least two message-sending condition-identifying portions, one of the condition-identifying portions including data indicating a message-receiving node or non-designation of a message-receiving node; and a comparison-selection circuit provided in each node includes registration parts for registering data of message-receiving conditions, at least two registration parts for comparing contents of the condition-identifying portion in the taken-in message with the data of message-receiving conditions registered in the registration parts, a received-message storing part for storing a message to be received in this node, a control part for determining whether or not the taken-in message is to be received in this node based on a result of comparison-processing performed in the comparison and selection means and for transferring the taken-in message to the received-message storing part if it is determined that the taken-in message is received in this node, otherwise, abandoning the taken-in message.
    • 在其中多个节点连接到传输线的分布式控制系统中,每个节点控制连接到该节点的组件并向其他节点发送消息,由每个节点发送的消息包括至少两个消息发送条件识别 条件识别部分中的一个包括指示消息接收节点的数据或消息接收节点的非指定; 并且在每个节点中提供的比较选择电路包括用于登记消息接收条件的数据的登记部分,用于将所述接收消息中的条件识别部分的内容与消息接收条件的数据进行比较的至少两个注册部分 登记在所述登记部分中,接收消息存储部分,用于存储要在该节点中接收的消息;控制部分,用于基于比较结果确定是否在该节点中接收到所接收的消息; 在比较和选择装置中执行的处理,并且如果确定在该节点中接收到接收消息,则将接收消息传送到接收消息存储部分,否则放弃接收消息。
    • 9. 发明授权
    • Distributed control system and filtering method used in the distributed control system
    • 分布式控制系统和分布式控制系统中使用的过滤方法
    • US06681139B1
    • 2004-01-20
    • US09353552
    • 1999-07-14
    • Masahiro OhashiTakeiki AizonoDai FujiiHiroyuki TanakaMakoto Kogure
    • Masahiro OhashiTakeiki AizonoDai FujiiHiroyuki TanakaMakoto Kogure
    • G05B1302
    • H04L29/06C04B2237/366H04L67/12
    • In a distributed control system with a plurality of nodes connected to a transmission line, each node controlling components and transmitting a message to other nodes, a message includes at least two message-sending condition-identifying portions, one of the portions including data indicating a message-receiving node or non-designation of a message-receiving node. A comparison-selection circuit in each node includes at least two registration parts for comparing contents of the condition-identifying portion in the taken-in message with the data of message-receiving conditions registered in the registration parts, a received-message storing part for storing a message to be received, a control part for determining whether or not the taken-in message is to be received based on a result of comparison-processing performed in the comparison and a selector transferring the taken-in message to the received-message storing part if it is determined that the taken-in message is to be received, otherwise, abandoning the taken-in message.
    • 在具有连接到传输线的多个节点的分布式控制系统中,每个节点控制组件并向其他节点发送消息,消息包括至少两个消息发送条件识别部分,其中的一个部分包括指示 消息接收节点或不指定消息接收节点。 每个节点中的比较选择电路包括至少两个注册部分,用于将所接收的消息中的条件识别部分的内容与登记在注册部分中的消息接收条件的数据进行比较;接收消息存储部分,用于 存储要接收的消息;控制部分,用于基于比较中执行的比较处理的结果以及选择器将接收消息传送到接收消息来确定是否要接收所接收的接收消息; 如果确定要接收到接收消息,则存储部分,否则放弃接收消息。
    • 10. 发明授权
    • Multiple-cable field bus system
    • 多电缆现场总线系统
    • US5757265A
    • 1998-05-26
    • US638202
    • 1996-04-26
    • Makoto KogureKoji TomaokiToshimitsu Tsuchihashi
    • Makoto KogureKoji TomaokiToshimitsu Tsuchihashi
    • H04B3/50H04L12/40H04Q9/00H04M11/04
    • H04L12/40006H04L12/40045H04L2012/40208
    • A field bus system may be used in which transmission ability of the system can be maintained even if communication error occurs due to noises or failure of a transmission line. The system can be easily shifted at a lower cost from a conventional system to the field bus system without degrading the high reliability thereof. The transmission line is constituted by a multiple-cable transmission line having at least three transmission cables. An external power supply supplies power to field devices through a pair of transmission cables of the multiple-cable transmission line. The field devices are connected to the transmission cables through a transmission line switching unit constituted by a plurality of rectifier elements, so that the field devices are supplied with current flowing in one predetermined direction when any of the pairs of transmission cables is selected. The external power supply monitors a failure of a currently used pair of transmission cables and, upon detection of failure of the currently used pair of transmission cables, the failed pair is replaced by a normal pair of transmission cables such that the field devices are continuously supplied with power.
    • 可以使用现场总线系统,其中即使由于传输线的噪声或故障而发生通信错误,系统的传输能力也可以保持。 该系统可以以较低成本容易地从常规系统转移到现场总线系统,而不会降低其高可靠性。 传输线由具有至少三个传输电缆的多电缆传输线构成。 外部电源通过多电缆传输线的一对传输电缆为现场设备供电。 现场设备通过由多个整流器元件构成的传输线路切换单元连接到传输电缆,使得当选择任何一对传输电缆时,向现场设备供应沿一个预定方向流动的电流。 外部电源监视当前使用的一对传输电缆的故障,并且在检测到当前使用的一对传输电缆的故障时,故障对由正常的一对传输电缆代替,使得现场设备被连续供电 有权力。