会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Calling signal transmission apparatus
    • 呼叫信号传输装置
    • US4748659A
    • 1988-05-31
    • US904495
    • 1986-09-08
    • Kiyoshi KasaharaKenichi OgawaKenji TakatoShoji NojiriYoshimi IijimaYasuo MiyazakiMitsutoshi AyanoKiyoshi ShibuyaAtsuo Serikawa
    • Kiyoshi KasaharaKenichi OgawaKenji TakatoShoji NojiriYoshimi IijimaYasuo MiyazakiMitsutoshi AyanoKiyoshi ShibuyaAtsuo Serikawa
    • H04M19/02
    • H04M19/026
    • In a calling signal transmitting apparatus, a ring trip equipment, including a ring trip detecting circuit for detecting a ring trip signal in response to an off-hook operation of the telephone set during a signal state of an intermittent ringing signal and a loop detecting circuit for detecting a loop signal in response to an off-hook operation of the telephone set during a nonsignal state of the intermittent ringing signal. Also included are a logical OR gate circuit, for providing, as a status signal, a logical sum of the ring trip signal and the loop signal, and a supervising circuit for supervising the status signal. When an incoming call is being received by the telephone set, when the supervising circuit detects an off-hook state in the status signal, the supervising circuit stops the transmission of a ringing signal to the telephone set, and carries out a second supervising operation for supervising the status signal, and, if an on-hook state is detected during the second supervising operation, said supervising circuit again transfers the ringing signal to the telephone set.
    • 在呼叫信号发送装置中,环路跳闸设备包括环路跳闸检测电路,用于在间歇振铃信号的信号状态期间响应于电话机的摘机操作来检测环路跳闸信号,以及环路检测电路 用于在间歇振铃信号的非信号状态期间响应于电话机的摘机操作来检测回路信号。 还包括逻辑或门电路,用于提供环路跳闸信号和环路信号的逻辑和作为状态信号,以及用于监视状态信号的监控电路。 当电话机接收到来电时,当监控电路在状态信号中检测到摘机状态时,监控电路停止向电话机发送振铃信号,并执行第二监视操作 监视状态信号,并且如果在第二监视操作期间检测到挂机状态,则所述监控电路再次将振铃信号传送到电话机。
    • 5. 发明授权
    • ISDN interface circuit and system using the same
    • ISDN接口电路和系统使用相同
    • US5311518A
    • 1994-05-10
    • US684272
    • 1991-04-12
    • Kenji TakatoYozo IketaniTakashi SatoHiroyuki UjiieSeiji Miyoshi
    • Kenji TakatoYozo IketaniTakashi SatoHiroyuki UjiieSeiji Miyoshi
    • H04M19/00H04Q5/00H04Q11/04H04J3/12
    • H04M19/005H04Q11/0471H04Q2213/08
    • An ISDN interface circuit is provided which is coupled to a terminal device via a transmission line and a reception line, the transmission line being formed of a pair of first and second wires, and the reception line being formed of a pair of third and fourth wires. The ISDN interface circuit includes a first resistor and a second resistor connected in series at a first node and between the first and second wires of the transmission line, and a third resistor and a fourth resistor connected in series at a second node and between the third and fourth wires of the reception line. The ISDN interface circuit also includes a D.C. power source connected to one of the first node, at which the first resistor and the second resistor are mutually connected in series and the second node, at which the third resistor and the fourth resistor are mutually connected in series. One of the first node and the second node, other than the above-mentioned one of the first node and the second node connected to the D.C. power source, is grounded.
    • 提供了一种ISDN接口电路,其经由传输线和接收线耦合到终端设备,所述传输线由一对第一和第二布线形成,并且所述接收线由一对第三和第四布线 。 ISDN接口电路包括第一电阻器和第二电阻器,第一电阻器和第二电阻器在第一节点处串联连接在传输线路的第一和第二导线之间,第三电阻器和第四电阻器在第二节点处串联连接, 和接收线的第四根线。 ISDN接口电路还包括连接到第一节点之一的DC电源,第一节点与第一电阻器和第二电阻器串联相互连接,第二节点在第二节点处连接第三电阻器和第四电阻器 系列。 除了连接到直流电源的第一节点和第二节点之一之外,第一节点和第二节点之一是接地的。
    • 7. 发明授权
    • Ground fault detector
    • 地面故障检测器
    • US5113426A
    • 1992-05-12
    • US573130
    • 1990-09-19
    • Kazumi KinoshitaKenji TakatoToshiro Tojo
    • Kazumi KinoshitaKenji TakatoToshiro Tojo
    • H04M3/30H04M19/00
    • H04M19/008H04M19/006H04M3/30
    • In a ground fault detector for long distance subscriber lines accommodated in a small capacity digital electronic exchange, a DC/DC converter for power supply is stopped during detection of ground fault. Upon reception of the stop signal, the DC/DC converter converts the power supply voltage for the subscribers to a voltage as the system power supply of the exchange, namely to a low voltage before voltage conversion of the DC/DC converter. The battery feed circuit can maintain the alarm condition, even if a current flows continuously to the battery feed resistor due to a ground fault, until the ground fault is recovered by the maintenance person without breaking the resistor.
    • PCT No.PCT / JP90 / 00036 Sec。 371 1990年9月19日第 102(e)1990年9月19日PCT PCT 1990年1月12日PCT公布。 出版物WO90 / 08441 日期:1990年7月26日。在容纳在小容量数字电子交换机中的长距离用户线路的接地故障检测器中,在接地故障检测期间停止用于电源的DC / DC转换器。 在接收到停止信号时,DC / DC转换器将用户的电源电压转换为电压作为交换机的系统电源,即在DC / DC转换器的电压转换之前为低电压。 即使电流由于接地故障而连续流向电池供电电阻,电池供电电路也可以保持报警状态,直到维护人员接地故障恢复,而不会中断电阻。
    • 9. 发明授权
    • Ring trip deciding circuit
    • 环路决定电路
    • US5402482A
    • 1995-03-28
    • US983864
    • 1993-03-05
    • Kazuyuki MinoharaKenji Takato
    • Kazuyuki MinoharaKenji Takato
    • H04M3/22H04M19/02H04M1/24H04M1/60H04M3/00H04M13/00
    • H04M3/2272H04M19/026
    • A ring trip deciding method in a ring trip circuit detects voltage change in the on-hook state and the on-hook state of a terminal when the terminal such as telephone set connected to the telephone line is called. The ring trip deciding circuit has a ring trip detecting resistance connected in series with a ringer generator for detecting change of current value depending on the on-hook and off-hook states, a detector for detecting voltage change across the ring trip detecting resistance, a voltage comparator for outputting different values when the threshold value is larger or smaller by comparing a voltage outputted from the detector with the threshold value, a first state latch for latching and outputting different state values depending on different output values of the voltage comparator, a composite state latch for fetching, latching and outputting at least two state values outputted from the first state latch synchronously with a clock, and a state deciding circuit for comparing state values of the composite state latch to detect the on-hook and off-hook states of the terminal.
    • PCT No.PCT / JP92 / 00863 Sec。 371日期1993年3月5日 102(e)日期1993年3月5日PCT提交1992年7月7日PCT公布。 出版物WO93 / 01676 日期:1993年1月21日。当呼叫连接到电话线的电话机等终端被调用时,环路跳闸电路中的环路决定方法检测挂机状态下的电压变化和终端的挂机状态。 环路决定电路具有与振铃发生器串联连接的环路跳闸检测电阻,用于根据挂机和摘机状态检测电流值的变化,用于检测环路跳闸检测电阻两端的电压变化的检测器, 电压比较器,用于通过将从检测器输出的电压与阈值进行比较而在阈值较大或更小时输出不同的值;第一状态锁存器,用于根据电压比较器的不同输出值进行锁存和输出不同的状态值;复合 状态锁存器,用于从时钟同步地获取,锁存和输出从第一状态锁存器输出的至少两个状态值;以及状态判定电路,用于比较复合状态锁存器的状态值,以检测复合状态锁存器的挂机和摘机状态 终点站。
    • 10. 发明授权
    • Battery feed circuit for supplying feed current to telephone set
    • 用于向电话机供电的电池供电电路
    • US5347577A
    • 1994-09-13
    • US939913
    • 1992-09-03
    • Kenji TakatoKazuhiro YoshidaKazuyuki Minohara
    • Kenji TakatoKazuhiro YoshidaKazuyuki Minohara
    • H04M19/00H04Q3/42
    • H04M19/005
    • A battery feed circuit supplies a feed current to a telephone set via a 2-wire telecommunication line formed of a TIP line and a RING line. The battery feed circuit includes a first voltage detection circuit for detecting a first voltage across the TIP line and a ground line, a second voltage detection circuit for detecting a second voltage across the RING line and a power line connected to a power supply of the battery feed circuit, a current source responsive to a first control signal for respectively generating first and second currents in the TIP and RING lines, the first and second currents being equal in magnitude and opposite in direction, the current source also varying the first and second currents in response to a second control signal so as to be in proportion to a common mode voltage across the TIP and RING lines, a first feedback circuit responsive to the first and second voltages detected by the first and second voltage detection circuits for generating the first control signal, and a second feedback circuit for generating the second control signal by detecting the common mode voltage across the TIP and RING lines.
    • 电池馈送电路通过由TIP线和RING线形成的2线电信线路向电话机提供馈电电流。 电池供给电路包括用于检测跨越TIP线和接地线的第一电压的第一电压检测电路,用于检测RING线两端的第二电压的第二电压检测电路和连接到电池的电源的电力线 馈电电路,响应于第一控制信号的电流源,用于分别在TIP和RING线中产生第一和第二电流,第一和第二电流在幅度上相等并且在方向上相反,电流源还改变第一和第二电流 响应于第二控制信号以与TIP和RING线两端的共模电压成比例的第一反馈电路,响应于由第一和第二电压检测电路检测的第一和第二电压,用于产生第一控制 信号和第二反馈电路,用于通过检测跨越TIP和RING的共模电压来产生第二控制信号 线条。