会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Limited restrike circuit interrupter used as a line capacitor and load switch
    • 有限重启电路断路器用作线路电容器和负载开关
    • US06316742B1
    • 2001-11-13
    • US09448198
    • 1999-11-23
    • Joseph R. RostronCary J. AhranoBrian J. Berner
    • Joseph R. RostronCary J. AhranoBrian J. Berner
    • H01H3304
    • H01R13/53H01H1/06H01H33/126
    • An actuator mechanism that decreases the time needed to move the contacts of a circuit interrupter between a closed circuit position and an open circuit position to reduce the probability of the occurrence of restrikes. The actuator mechanism uses a toggle spring arrangement that uses a single spring to move the interrupter through both an opening stroke and a closing stroke. The interrupter is designed to connect to the circuit in parallel, so that the interrupter is not normally in the circuit when the circuit is closed. Because the interrupter is not normally in the circuit, it can be manufactured to less stringent standards than those that apply to electrical components that normally remain in the circuit. The interrupter is well adapted for use as a puffer-type interrupter in which the contacts of the interrupter are contained in an arc-extinguishing gas, such as sulphur-hexaflouride (SF6) gas to further reduce the probability of restrikes and to minimize the effect of occurring restrikes. The interrupter has a bellows arrangement that provides a seal to contain the sulphur-hexaflouride (SF6) gas while allowing the actuator mechanism to freely operate without deterioration of interrupter components. The bellows arrangement enables the interrupter to be utilized in capacitor switching applications in which frequent switching is required. The interrupter may also include a voltage-clamping device connected in parallel across the contacts of the circuit interrupter.
    • 一种致动器机构,其减小了在闭路位置和开路位置之间移动断路器的触点所需的时间,以减少再起弧的发生概率。 致动器机构使用肘节弹簧装置,其使用单个弹簧来通过打开行程和闭合行程来移动断续器。 断路器被设计成并联连接到电路,使得当电路闭合时,断路器通常不在电路中。 由于断路器通常不在电路中,因此可以制造出比通常保留在电路中的电气部件的标准要低的标准。 断路器很适合用作吹气式断路器,其中断流器的触点包含在灭弧气体中,例如硫 - 六氟化物(SF6)气体,以进一步降低再起弧的可能性并使效果最小化 发生重击。 断路器具有波纹管布置,其提供密封以容纳硫 - 六氟化物(SF6)气体,同时允许致动器机构自由操作而不损坏断续器部件。 波纹管布置使断路器能够用于需要频繁切换的电容器开关应用中。 断路器还可以包括并联连接在电路断续器的触点上的电压钳位装置。
    • 2. 发明授权
    • Limited restrike electric power circuit interrupter suitable for use as a line capacitor and load switch
    • US06583978B2
    • 2003-06-24
    • US09882856
    • 2001-06-15
    • Joseph R. RostronCary J. AhranoBrian J. Berner
    • Joseph R. RostronCary J. AhranoBrian J. Berner
    • H02H900
    • H01R13/53H01H1/06H01H33/126
    • An actuator mechanism that decreases the time needed to move the contacts of a circuit interrupter between a closed circuit position and an open circuit position to reduce the probability of the occurrence of restrikes. The actuator mechanism uses a toggle spring arrangement that uses a single spring to move the interrupter through both an opening stroke and a closing stroke. The interrupter is designed to connect to the circuit in parallel, so that the interrupter is not normally in the circuit when the circuit is closed. Because the interrupter is not normally in the circuit, it can be manufactured to less stringent standards than those that apply to electrical components that normally remain in the circuit. The interrupter is well adapted for use as a puffer-type interrupter in which the contacts of the interrupter are contained in an arc-extinguishing gas, such as sulphur-hexaflouride (SF6) gas to further reduce the probability of restrikes and to minimize the effect of occurring restrikes. The interrupter has a bellows arrangement that provides a seal to contain the sulphur-hexaflouride (SF6) gas while allowing the actuator mechanism to freely operate without deterioration of interrupter components. The bellows arrangement enables the interrupter to be utilized in capacitor switching applications in which frequent switching is required. The interrupter may also include a voltage-clamping device connected in parallel across the contacts of the circuit interrupter.
    • 4. 发明授权
    • Capacitor switch with external resistor and insertion whip
    • 电容开关带外部电阻和插入鞭状
    • US06483679B1
    • 2002-11-19
    • US09883587
    • 2001-06-18
    • Raj AnandJoseph R. RostronCary J. Ahrano
    • Raj AnandJoseph R. RostronCary J. Ahrano
    • H01G212
    • H01H33/167H01H33/166Y10T307/826Y10T307/832
    • An interrupter switch mechanism 18, an actuator mechanism 20 for operating the switch mechanism 18, an engagement arm 30 such as a whip, a first resistor 22, a second resistor 26, a drive mechanism 64 for pivoting the engagement arm 30 into contact with the resistors 22 and 26, and a drive shaft 62. The drive mechanism 64 has a first hub 82, a second hub 84 that is biased relative to the first hub 82, and a pivotal latch member 66 that is biased towards an engaged position with the second hub 94. The drive shaft 62 sequentially operates the drive mechanism 64 to introduce the first resistor 22 and then the second resistor 26, and then operates the actuator 20 to close the switch mechanism 18, for reducing electrical disturbances when switching a capacitor bank 12 into an electric power circuit 16.
    • 断续器开关机构18,用于操作开关机构18的致动器机构20,诸如鞭子的接合臂30,第一电阻器22,第二电阻器26,用于将接合臂30枢转到与接触臂30接触的驱动机构64。 电阻器22和26以及驱动轴62.驱动机构64具有第一轮毂82,相对于第一轮毂82偏置的第二轮毂84和枢转的闩锁部件66, 第二毂94.驱动轴62依次操作驱动机构64以引入第一电阻器22和第二电阻器26,然后操作致动器20以闭合开关机构18,以便在切换电容器组12时减小电气干扰 进入电力电路16。
    • 5. 发明授权
    • High impedance fault isolation system
    • 高阻抗故障隔离系统
    • US08717721B2
    • 2014-05-06
    • US13217318
    • 2011-08-25
    • Joseph R. Rostron
    • Joseph R. Rostron
    • H02H3/08
    • H02H3/083
    • A high impedance fault isolation system for a radially connected three phase electric power line that utilizes three phase current measurements to determine the presence of a fault without the need for any voltage measurements or a battery powered controller. This eliminates the need for costly phase voltage measuring devices conventionally required to detect high impedance faults, which makes it economical to install fault isolation system at a greater number of locations throughout the power system. The system detects faults using current measurements by computing the negative and zero sequence current components and comparing the amplitudes of the negative and zero sequence components. A fault is detected when the ratio of the amplitudes of the negative and zero sequence components falls within a predefined fault detection range, such as the range from 0.5 to 1.5.
    • 用于径向连接的三相电力线的高阻抗故障隔离系统,其利用三相电流测量来确定故障的存在而不需要任何电压测量或电池供电的控制器。 这消除了对传统上需要检测高阻抗故障的昂贵的相电压测量装置的需要,这使得在整个电力系统中更多数量的位置安装故障隔离系统是经济的。 该系统通过计算负序和零序电流分量并比较负序和零序分量的振幅来检测故障。 当负序和零序分量的振幅的比值落在预定义的故障检测范围内,例如0.5至1.5的范围时,检测到故障。
    • 7. 发明授权
    • Current monitoring device for high voltage electric power lines
    • 高压电力线电流监测装置
    • US07683798B2
    • 2010-03-23
    • US11774955
    • 2007-07-09
    • Joseph R. Rostron
    • Joseph R. Rostron
    • G08B21/00
    • G01R1/04G01R15/14G01R19/2513
    • A current monitoring device (CMD) with a set of electromagnetic field sensors located within one or more grounded housings positioned within the combined electromagnetic fields generated by one or more electric power lines. The CMD includes electronics, typically located within the grounded housings, defining impedance networks that combine the measurements received from the field sensors to create output signal indicative of electric current values for the phase conductors. The housings can be conveniently attached and to transmission line towers, distribution line poles, and high voltage power line supports in transmission and distribution substations. The CMD controls response equipment, such as a circuit interrupter that responds to current disturbances detected by the CMD. The CMD may also include communication for sending the current values to a remote controller, such as a central control station, that implements a wide range of response equipment.
    • 一种具有位于由一个或多个电力线产生的组合电磁场内的一个或多个接地壳体内的一组电磁场传感器的电流监测装置(CMD)。 CMD包括通常位于接地壳体内的电子元件,其定义阻抗网络,其组合从现场传感器接收的测量值,以产生指示相导体的电流值的输出信号。 外壳可以方便地连接到输电和配电变电站中的传输线塔,配电线极和高压电力线支架。 CMD控制响应设备,例如响应CMD检测到的电流干扰的电路断路器。 CMD还可以包括用于将当前值发送到实现各种响应设备的远程控制器(例如中央控制站)的通信。
    • 8. 发明授权
    • Voltage based VAR compensation system
    • 基于电压的VAR补偿系统
    • US5900723A
    • 1999-05-04
    • US919465
    • 1997-08-28
    • Joseph R. Rostron
    • Joseph R. Rostron
    • H02J3/18G05F1/70
    • H02J3/1878Y02E40/30
    • A VAR generator compensation system wherein the voltage of the capacitor or reactor bank is changed as a means of adjusting the phase angle is taught. Briefly stated a reactive bank such as a capacitor bank is connected to the secondary of an autotransformer such that the voltage of the reactive bank is controlled by the autotransformer. The line and load are connected to the primary of the autotransformer, such that changing the voltage of the autotransformer and hence the secondary voltage connected to the reactive bank, thus changes the VARS generated on the grid or system.
    • 教导了一种VAR发生器补偿系统,其中电容器或电抗器组的电压作为调整相位角的方式改变。 简要地说,诸如电容器组的电抗器组连接到自耦变压器的次级,使得反应体的电压由自耦变压器控制。 线路和负载连接到自耦变压器的主要,从而改变自耦变压器的电压,从而改变连接到电抗器组的次级电压,从而改变电网或系统上产生的VARS。