会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 5. 发明授权
    • Multirate wireless data communication system
    • 多速率无线数据通信系统
    • US5706428A
    • 1998-01-06
    • US615408
    • 1996-03-14
    • Jan BoerWilhelmus Josephus DiepstratenAdriaan KamermanHendrik van BokhorstHans van Driest
    • Jan BoerWilhelmus Josephus DiepstratenAdriaan KamermanHendrik van BokhorstHans van Driest
    • H04B1/707H04L12/28H04L12/56H04Q1/30
    • H04B1/707H04B2201/70703H04W28/22H04W4/12H04W84/12
    • A wireless LAN includes first stations adapted to operate at a 1 or a 2 Mbps data rate and second stations adapted to operate at a 1,2,5 or 8 Mbps data rate. The 1 and 2 Mbps rates use DBPSK and DQPSK modulation, respectively. The 5 and 8 Mbps rates use PPM/DQPSK modulation. All four data rates use direct sequence spread spectrum (DSSS) coding. All transmitted messages start with a preamble and header at the 1 Mbps rate. The header includes fields identifying the data rate for the data portion of the message, and a length field. For a 2 Mbps transmission the length field identifies the number of bytes in the data field. For a 5 or 8 Mbps the length field identifies the number of bytes in the data field which, if transmitted at 2 Mbps, would take the same transmission time of the data field, and is thus a fraction 2/5 or 2/8 of the actual number of the bytes. With this arrangements, all the stations are interoperable in a co-existent manner in the LAN.
    • 无线LAN包括适于以1或2Mbps数据速率操作的第一站和适于以1,2,5或8Mbps数据速率操作的第二站。 1和2Mbps速率分别使用DBPSK和DQPSK调制。 5和8 Mbps速率使用PPM / DQPSK调制。 所有四种数据速率都使用直接序列扩频(DSSS)编码。 所有发送的消息以1 Mbps速率从前同步码和报头开始。 标题包括标识消息的数据部分的数据速率的字段和长度字段。 对于2Mbps传输,长度字段标识数据字段中的字节数。 对于5或8 Mbps,长度字段标识数据字段中的字节数,如果以2 Mbps发送,则将占用数据字段的相同传输时间,因此为小数+ E,fra 2/5 + EE或+ E,fra 2/8 + EE的实际字节数。 通过这种安排,所有的台站可以在局域网中以共存的方式进行互操作。
    • 9. 发明授权
    • Wireless lan with enhanced capture provision
    • 无线网络具有增强的捕获条件
    • US5987033A
    • 1999-11-16
    • US925416
    • 1997-09-08
    • Jan BoerHendrik van BokhorstWilhelmus Josephus DiepstratenAdriaan KamermanRienk MudHans van DriestRobert John Kopmeiners
    • Jan BoerHendrik van BokhorstWilhelmus Josephus DiepstratenAdriaan KamermanRienk MudHans van DriestRobert John Kopmeiners
    • H04L12/28H04B7/00H04L12/413H04Q7/00
    • H04W74/0816Y02B60/50
    • A receiver, and a method for operating the receiver, for a station in a wireless local area network using a common wireless communication channel and employing a CSMA/CA (carrier sense multiple access with collision avoidance) protocol includes various modes. In normal mode, the receiver follows typical states in order to detect a message and demodulate data from the message properly. Meanwhile, a process implements a message-in-message (MIM) mode when an energy increase above a specified level is detected. While in the MIM mode, if a carrier is detected, the energy increase is caused by a new message; otherwise, the energy increase is caused by an interfering station. If the carrier is detected, the receiver begins retraining so that it can start receiving the new message as soon as the first message ends. If no carrier is detected, the receiver waits a specified time to detect a carrier or for the end of the first message, after which the receiver returns to the beginning of the normal mode. While in the normal mode, if a message is detected that is not addressed to the station, the receiver enters a hunt mode. While in the hunt mode, the receiver waits for the current message to finish. At the same time, a process implements retraining when both an energy increase above a specified level and a carrier are detected. If no carrier is detected within a specified time, or if the energy level decreases below the specified level, the receiver returns to the beginning of the normal mode.
    • 使用公共无线通信信道和采用CSMA / CA(具有冲突避免的载波侦听多路访问)协议的无线局域网中的站的接收机和操作接收机的方法包括各种模式。 在正常模式下,接收机遵循典型状态,以便检测消息并正确地解调消息中的数据。 同时,当检测到高于指定电平的能量增加时,处理实现消息消息(MIM)模式。 在MIM模式下,如果检测到载波,则能量增加是由新信息引起的; 否则,能量增加是由干扰站造成的。 如果检测到载波,则接收机开始重新训练,以便在第一个消息结束时,它可以开始接收新消息。 如果没有检测到载波,则接收机等待指定的时间来检测载波或第一个消息的结束,接收机返回到正常模式的开始。 在正常模式下,如果检测到没有寻址到站的消息,则接收机进入寻线模式。 在寻线模式下,接收机等待当前消息完成。 同时,当检测到高于指定水平的能量增加和载波时,过程实施再训练。 如果在指定时间内没有检测到载波,或者能量水平降低到指定的电平以下,则接收机返回正常模式的开始。