会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • High-voltage milberger slip slide power conditioner
    • 高压米勒滑盖功率调节器
    • US4698742A
    • 1987-10-06
    • US891821
    • 1986-08-01
    • Franklin B. JonesWalter E. MilbergerDavid E. BulgherCharles S. Kerfoot
    • Franklin B. JonesWalter E. MilbergerDavid E. BulgherCharles S. Kerfoot
    • H02M3/28H02M7/497H02M7/515H02M7/00
    • H02M7/497H02M3/285
    • A high-voltage converter circuit which uses a slip slide power conditioner to reduce non-monotonic non-linearities in the converter output signal is disclosed. The slip slide power conditioner includes: a choke feed D.C. circulator; two radio frequency (RF) power pumps; a phase detector; a phase controller; and a combiner. The choke feed D.C. circulator receives the D.C. input signal and produces therefrom two voltage output signals which are each sent to one of the two RF power pumps. The two RF power pumps produce two out-of-phase square wave output signals which are algebraically combined in the combiner to form an output signal whose amplitude is a function of phase difference. The phase detector and phase controller sample this output signal and adjust the phase of the two power pumps to remove non-linearities due to secondary ranging (resonance) that beats with harmonics of their square wave signals.
    • 公开了一种使用滑动滑动功率调节器来降低转换器输出信号中的非单调非线性度的高压转换器电路。 滑动滑块功率调节器包括:扼流喂料直流循环器; 两台射频(RF)动力泵; 相位检测器; 相位控制器 和组合器。 扼流进给直流循环器接收直流输入信号并由此产生两个电压输出信号,每个电压输出信号被发送到两个RF功率泵中的一个。 两个RF功率泵产生两个异相方波输出信号,它们在组合器中被代数组合以形成其幅度是相位差的函数的输出信号。 相位检测器和相位控制器对此输出信号进行采样,并调整两个功率泵的相位,以消除由于其方波信号的谐波而产生的二次测距(谐振)引起的非线性。
    • 5. 发明授权
    • Wide band domino effect high voltage regulator
    • 宽带多米诺效应高压调节器
    • US5070538A
    • 1991-12-03
    • US459870
    • 1990-01-02
    • Walter E. MilbergerCharles S. KerfootFranklin B. Jones
    • Walter E. MilbergerCharles S. KerfootFranklin B. Jones
    • G05F1/44G05F1/595H03F1/02H03F3/21H03F3/217H03F3/24H03F3/42
    • H03F3/2171G05F1/44G05F1/595H03F1/0283H03F3/211H03F3/245H03F3/426
    • The high voltage regulator employs a field effect transistor (FET) amplifier and a wide band frequency compensated RC voltage divider. The device comprises a FET amplifier used as a current source in a 20 KV power supply. The negative output of the supply is sensed by a voltage divider consisting of two resistors in parallel with two capacitors. The voltage divider output is applied to the non-inverting input of an operational amplifier whose reference is set to affect the linear operation of an inverting operational amplifier. A no load to full load and line regulation of 0.1% is provided to a microwave tube. For a 16-KV regulated output the inverting amplifier must have a dc operation point of 4 KV to accommodate a 20% storage capacitor voltage droop and a .+-.5% line change. At this level the inverting amplifier provides a swing of .+-.4 KV. This range allows for a large line voltage variation and storage capacitor voltage droop. The dynamic range and bandwidth of the regulator not only provides regulation for long term line voltage regulation but also negates the effects of line voltage transitions over a wide frequency and amplitude range.
    • 高压稳压器采用场效应晶体管(FET)放大器和宽带频率补偿RC分压器。 该器件包括用作20 KV电源中的电流源的FET放大器。 电源的负输出由两个电阻并联的两个电容器组成的分压器检测。 分压器输出被施加到运算放大器的非反相输入,其基准被设置为影响反相运算放大器的线性运算。 向微波管提供0.1%的满载和线路调节空载。 对于16-KV调节输出,反相放大器必须具有4 KV的直流工作点,以适应20%的存储电容电压下降和+/- 5%的线变化。 在此级别,反相放大器提供+/- 4 KV的摆幅。 该范围允许大的线路电压变化和存储电容器电压下降。 调节器的动态范围和带宽不仅可以提供长期线路电压调节的调节功能,而且可以抵消宽频率和幅度范围内线路电压转换的影响。
    • 7. 发明授权
    • Domino effect amplifier
    • 多米诺效应放大器
    • US4897617A
    • 1990-01-30
    • US318211
    • 1989-02-28
    • Walter E. MilbergerFranklin B. JonesCharles S. Kerfoot
    • Walter E. MilbergerFranklin B. JonesCharles S. Kerfoot
    • H03F3/42
    • H03F3/426
    • This high voltage linear FET amplifier operates at voltage levels of ten's of thousand's of volts with power dissipation capabilities in the kilowatt range. It is a broadband device which features power amplification from DC to frequencies well in excess of 100 KHz. The amplifier uses a unity-gain inverting amplifier as its basic building block. N-number of these building blocks are stacked to accommodate whatever voltage stand-off level is desired. To operate stacked high voltage amplifiers, it is necessary to provide a bias shift (reference) progressively increasing in equal increments from the ground reference stage to the highest voltage level stage while preserving the fidelity of the signal applied to the first stage. This is done by establishing a phantom ground at all amplifiers for each progressive bias level.
    • 该高压线性FET放大器的工作电压为千伏特的十分之一,功率耗散功率在千瓦范围内。 它是一种宽带设备,具有从DC到超过100 KHz的频率功率放大。 放大器使用单位增益反相放大器作为其基本构建块。 N个这些构建块被堆叠以适应任何需要的电压待机水平。 为了操作堆叠高压放大器,有必要提供从地面基准级到最高电压级阶段以相等增量逐渐增加的偏置偏移(参考),同时保持施加到第一级的信号的保真度。 这是通过在每个渐进偏置电平的所有放大器上建立幻影地来完成的。