会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明授权
    • Starting and synchronizing system for line-start permanent magnet motor
    • 线启动永磁电机的启动和同步系统
    • US5859513A
    • 1999-01-12
    • US42374
    • 1998-03-13
    • Charles Michael StephensPaul Michael Szczesny
    • Charles Michael StephensPaul Michael Szczesny
    • H02P1/50
    • H02P1/50
    • A system for preventing objectionable large torque pulsations during the starting and synchronization of a line-start permanent magnet motor compares motor speed with motor synchronous speed and power source phase with the motor back-emf phasor. The motor starting armature is coupled to the power source and the PM armature is disconnected from the power source before motor speed has reached to within a predetermined margin of synchronous speed and before the back-emf phasor has dropped below a predetermined phase difference. After motor speed has approached synchronous speed to within the margin and the phase difference has dropped below the predetermined phase difference, connections are reversed so that the starting armature is disconnected from the power source and the PM armature is coupled to the power source.
    • 在线路启动永磁电动机的启动和同步期间防止不利的大的扭矩脉动的系统将电动机速度与电动机反向电动机的电动机同步速度和电源相位进行比较。 电动机启动电枢与电源耦合,并且在电动机速度达到同步速度的预定余量之前以及在反电动势相对下降到预定相位差之前,PM电枢与电源断开连接。 在电机速度接近同步速度到裕度之间并且相位差已经降到低于预定相位差之前,连接被反转,使得起动电枢从电源断开,并且PM电枢耦合到电源。
    • 2. 发明授权
    • Active damping control for active power filter
    • 有源电力滤波器的主动阻尼控制
    • US5691626A
    • 1997-11-25
    • US474212
    • 1995-06-07
    • Albert Andreas Maria EsserPaul Michael SzczesnyJeffrey Joseph NasadoskiRobert Joseph BastianPeter Claudius Sanza
    • Albert Andreas Maria EsserPaul Michael SzczesnyJeffrey Joseph NasadoskiRobert Joseph BastianPeter Claudius Sanza
    • H02J3/01H02J3/18G05F3/00G05F1/70
    • H02J3/1835H02J3/01Y02E40/22
    • An active damping control device for an active power filter includes a filter circuit having an inductor and a capacitor for suppressing noise in the active power filter; a first current sensor for sensing a three phase capacitor current of the filter capacitor; a second current sensor for detecting a three phase load current; and an active power filter controller for extracting the fundamentals of the capacitor and load currents and calculating a reference current for the active power filter. The active power filter controller can include a phase locked loop device or a notch filter for receiving a grid voltage and providing a corresponding voltage angle; first and second discrete fourier transform devices for using the voltage angle and the capacitor and load currents for extracting the fundamentals of the capacitor and load currents, respectively, and providing respective first and second output currents; and a subtractor for subtracting the first output current from the second output current to obtain the reference current. The active power filter can further include, situated between the first discrete fourier transform device and the subtractor, a multiplier for multiplying the first output current by a predetermined factor and a high pass filter for filtering the first output current. The filter circuit can include a circuit breaker coupling the inductor, the capacitor, and the first current sensor to the load for providing overcurrent protection to the filter circuit.
    • 一种有源电力滤波器的主动阻尼控制装置,包括具有用于抑制有源电力滤波器中的噪声的电感器和电容器的滤波电路; 用于感测滤波电容器的三相电容器电流的第一电流传感器; 用于检测三相负载电流的第二电流传感器; 以及有源电力滤波器控制器,用于提取电容器的基本原理和负载电流,并计算有功功率滤波器的参考电流。 有源电力滤波器控制器可以包括锁相环装置或陷波滤波器,用于接收电网电压并提供对应的电压角; 第一和第二离散傅里叶变换装置,分别使用电压角和电容器和负载电流分别提取电容器的基本面和负载电流,并提供相应的第一和第二输出电流; 以及用于从第二输出电流减去第一输出电流以获得参考电流的减法器。 有源电力滤波器可以进一步包括位于第一离散傅里叶变换装置和减法器之间的乘法器,用于将第一输出电流乘以预定因子,以及用于过滤第一输出电流的高通滤波器。 滤波器电路可以包括将电感器,电容器和第一电流传感器耦合到负载的断路器,以向滤波器电路提供过电流保护。
    • 3. 发明授权
    • Active filter control
    • 有源滤波器控制
    • US5648894A
    • 1997-07-15
    • US315473
    • 1994-09-30
    • Rik Wivina Anna Adelson DeDonckerPaul Michael Szczesny
    • Rik Wivina Anna Adelson DeDonckerPaul Michael Szczesny
    • H02J3/01H02M7/5387H02M1/12
    • H02M7/53873H02J3/1842Y02E40/22
    • A set of command signals is generated for application to the respective lines of a four-wire three phase power distribution system to compensate for harmonic distortion and neutral unbalance. A transform operation is performed upon a first set of signals, which collectively represent the uncompensated load current in each of the main transmission lines of the power distribution system, to generate a second set of signals which collectively represent the active and reactive components of the current in the system. Signal components at the fundamental frequency of the three phase system are removed from the active and reactive components to provide only harmonic active and reactive components. A reverse transform operation is performed upon the harmonic components to provide a set of command signals.
    • 生成一组命令信号以应用于四线制三相配电系统的各个线路,以补偿谐波失真和中性不平衡。 对第一组信号执行变换操作,这些信号共同表示配电系统的每个主传输线中的未补偿的负载电流,以产生共同表示电流的有功和无功分量的第二组信号 在系统中。 三相系统基频的信号分量从有功和无功分量中去除,仅提供谐波有功和无功分量。 对谐波分量执行反向变换操作以提供一组命令信号。
    • 4. 发明授权
    • System and method for compensating for line imbalances in line commutated converters
    • 用于补偿线路整流转换器中线路不平衡的系统和方法
    • US06563722B1
    • 2003-05-13
    • US09703736
    • 2000-11-02
    • Vinod JohnLuis Jose GarcesPeter Claudius SanzaPaul Michael Szczesny
    • Vinod JohnLuis Jose GarcesPeter Claudius SanzaPaul Michael Szczesny
    • H02H7125
    • H02J3/1814H02P23/186Y02E40/18
    • A method and system for compensating for line imbalances in line commutated converters. The controller includes a phase-locked loop (PLL) synchronizing tool which receives the line to line voltage signals and generates firing angle and frequency signals used for synchronizing the two input signals. The PLL controller, in addition to the firing angle and frequency signals, also generates signals representative of filtered values of amplitudes for each of the line to line voltage signals. A voltage imbalance compensation processor associated with the bridge firing controller receives the filtered amplitude signals and also a signal representative of the firing sector of the bridge. The voltage imbalance compensation processor generates, based upon the sector signal and the received filtered amplitude signals a amplitude signal used by a current regulator which is compensated for line imbalances present in the line voltage.
    • 一种用于补偿线路换向转换器中线路不平衡的方法和系统。 该控制器包括锁相环(PLL)同步工具,其接收线间电压信号,并产生用于同步两个输入信号的触发角和频率信号。 除了触发角和频率信号之外,PLL控制器还产生表示每个线对电压信号的滤波值的滤波值的信号。 与桥接启动控制器相关联的电压不平衡补偿处理器接收经滤波的幅度信号以及代表桥接器的发射扇区的信号。 电压不平衡补偿处理器基于扇区信号和接收到的滤波幅度信号产生电流调节器使用的振幅信号,电流调节器补偿线路电压中存在的线路不平衡。
    • 6. 发明授权
    • System and method for compensating for voltage notches in two-phase phase locked loops
    • 用于补偿两相锁相环电压缺口的系统和方法
    • US06278623B1
    • 2001-08-21
    • US09704246
    • 2000-11-02
    • Luis Jose GarcesVinod JohnPeter Claudius SanzaPaul Michael Szczesny
    • Luis Jose GarcesVinod JohnPeter Claudius SanzaPaul Michael Szczesny
    • H02M112
    • H02M7/1623H02M1/12H02M7/1552H02M2007/2195Y02B70/1408Y10S388/911Y10S388/917
    • A method and system for compensating for voltage notches in phase locked loop (PLL) control devices. A bridge firing controller receives signals representative of two of the line to line voltages received by the bridge. The controller includes a PLL synchronizing tool which receives the line to line voltage signals and generates a synchronizing phase error signal for aligning the phases of the two input signals. The controller, for a predetermined period following bridge firing, determines whether a voltage notch has occurred. If so, the controller substitutes model control signals for actual control signals so as to reduce the effect of the notch on the generated phase error signal used for synchronization. If not, the controller continues to use the actual control signals to generate the phase error signal. Once the predetermined period has expired, the controller utilizes the actual control signals to generate the phase error signal.
    • 一种补偿锁相环(PLL)控制装置电压缺口的方法和系统。 桥接发射控制器接收代表由桥接收的线对电压中的两个的信号。 该控制器包括一个PLL同步工具,它接收线间电压信号,并产生用于对准两个输入信号的相位的同步相位误差信号。 控制器在桥接点火之后的预定时间内确定是否发生了电压缺口。 如果是这样,控制器将模型控制信号替换为实际控制信号,以便减小所产生的相位误差信号用于同步的影响。 如果不是,则控制器继续使用实际的控制信号来产生相位误差信号。 一旦预定时间段到期,控制器利用实际控制信号产生相位误差信号。
    • 8. 发明授权
    • Method and system for detecting a zero current level in a line commutated converter
    • 用于检测线路整流转换器中的零电流电平的方法和系统
    • US06385066B1
    • 2002-05-07
    • US09702642
    • 2000-11-01
    • Luis Jose GarcesVinod JohnPeter Claudius SanzaPaul Michael Szczesny
    • Luis Jose GarcesVinod JohnPeter Claudius SanzaPaul Michael Szczesny
    • H02M542
    • H02M1/32H02M7/1623H02M2001/0012
    • A method and system for determining zero current level occurrences in a reversible power converter without requiring additional component complexity and costs. A digital controller selectively determines the line to line voltage for the most recently fired thyristor pair. The selected line to line voltage is identified as the bridge reconstruction voltage and is compared against the actual bridge output voltage for the conducting bridge. The difference between the two voltage signals is identified as the bridge error voltage and the sign of its magnitude is indicative of a load current zero level occurrence. A zero current level occurrence happens whenever the bridge error voltage drops below zero. This indication is positive and substantially instantaneous and safely enables the reversal of power flow without the risk of line faults due to cross-bridge short circuits.
    • 用于确定可逆功率转换器中的零电流电平发生的方法和系统,而不需要额外的组件复杂性和成本。 数字控制器选择性地确定最近烧制的晶闸管对的线间电压。 所选择的线间电压被确定为桥重建电压,并与导电桥的实际桥输出电压进行比较。 两个电压信号之间的差异被识别为桥接误差电压,其大小的符号表示负载电流零电平发生。 每当桥接误差电压低于零时,就会发生零电流电平。 该指示是正的并且基本上是瞬时的并且安全地实现功率流的反转,而不会由于交叉桥短路而导致线路故障的风险。