会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明公开
    • Demodulation pixel incorporating majority carrier current, buried channel and high-low junction
    • Demodulationspixel umfassenderMajoritätsträgerstrom,eingegrabener Kanal und Hoch-Niedrig-Verbindung
    • EP2284897A2
    • 2011-02-16
    • EP10172890.5
    • 2010-08-16
    • Buettgen, BernhardFelber, JonasLehmann, MichaelOggier, Thierry
    • Buettgen, BernhardFelber, JonasLehmann, MichaelOggier, Thierry
    • H01L27/148
    • H01L27/14812H01L27/14806
    • A demodulation pixel improves the charge transport speed and sensitivity by exploiting two effects of charge transport in silicon in order to achieve the before-mentioned optimization. The first one is a transport method based on the CCD gate principle. However, this is not limited to CCD technology, but can be realized also in CMOS technology. The charge transport in a surface or even a buried channel close to the surface is highly efficient in terms of speed, sensitivity and low trapping noise. In addition, by activating a majority carrier current flowing through the substrate, another drift field is generated below the depleted CCD channel. This drift field is located deeply in the substrate, acting as an efficient separator for deeply photo-generated electron-hole pairs. Thus, another large amount of minority carriers is transported to the diffusion nodes at high speed and detected.
    • 解调像素通过利用硅中的电荷传输的两种效应来提高电荷传输速度和灵敏度,以实现前述的优化。 第一种是基于CCD门原理的传输方法。 然而,这不仅限于CCD技术,而且还可以在CMOS技术中实现。 在表面或甚至靠近表面的掩埋通道中的电荷传输在速度,灵敏度和低陷阱噪声方面是高效的。 此外,通过激活流过衬底的多数载流子电流,在耗尽的CCD通道之下产生另一个漂移场。 该漂移场深深地位于衬底中,作为深色光电子 - 空穴对的有效分离器。 因此,另外大量少数载体被高速运送到扩散节点并进行检测。
    • 9. 发明申请
    • DEMODULATION PIXEL WITH DAISY CHAIN CHARGE STORAGE SITES AND METHOD OF OPERATION THEREFOR
    • 具有大型链式充电储存站的解调像素及其操作方法
    • WO2010025331A1
    • 2010-03-04
    • PCT/US2009/055309
    • 2009-08-28
    • MESA IMAGING AGHOUSTON, J. GrantLEHMANN, MichaelBUETTGEN, Bernhard
    • LEHMANN, MichaelBUETTGEN, Bernhard
    • H04N5/335H01L27/146H01L31/113
    • H04N5/335G01S7/4914H01L27/14603H01L27/14609H04N5/369
    • A demodulation pixel architecture allows for demodulating an incoming modulated electromagnetic wave, normally visible or infrared light. It is based on a charge coupled device (CCD) line connected to a drift field structure. The drift field is exposed to the incoming light. It collects the generated charge and forces it to move to the pick-up point. At this pick-up point, the CCD element samples the charge for a given time and then shifts the charge packets further on in the daisy chain. After a certain amount of shifts, the multiple charge packets are stored in so-called integration gates, in a preferred embodiment. The number of integration gates gives the number of simultaneously available taps. When the cycle is repeated several times, the charge is accumulated in the integration gates and thus the signal-to-noise ratio increases. The architecture is flexible in the number of taps. A dump node can be attached to the CCD line for dumping charge with the same speed as the samples are taken. Different implementations are described herein, which allow for smaller design or faster speed. The pixel structure can be exploited for e.g. 3D time-of-flight imaging. Both heterodyne and homodyne measurements are possible. Due to the highly-efficient charge transport enabled by static drift fields in the photo-sensitive region and small-sized gates in the CCD chain, high frequency bandwidth from just a few Hertz (Hz) up to greater GHz is supported. Thus, the pixel allows for highly-accurate optical distance measurements. Another possible application of this pixel architecture is fluorescence lifetime imaging microscopy (FLIM), where short laser pulses for triggering the fluorescence have to be suppressed.
    • 解调像素架构允许解调通常可见或红外光的输入调制电磁波。 它是基于连接到漂移场结构的电荷耦合器件(CCD)线。 漂移场暴露于入射光。 它收集产生的电荷并迫使其移动到接收点。 在该拾取点,CCD元件对给定时间的电荷进行采样,然后在菊花链中进一步移动电荷分组。 在优选实施例中,在一定量的位移之后,多个电荷包被存储在所谓的积分门中。 集成门数提供同时可用的抽头数。 当周期重复多次时,电荷积聚在积分门中,因此信噪比增加。 该体系结构灵活的抽头数量。 转储节点可以连接到CCD线,以与采样相同的速度倾倒电荷。 这里描述了不同的实施方式,其允许更小的设计或更快的速度。 像素结构可以被利用来实现。 3D飞行时间成像。 外差和零差测量都是可能的。 由于光敏区域的静态漂移场和CCD链中的小尺寸栅极实现了高效率的电荷传输,因此支持从几赫兹(Hz)到更高GHz的高频带宽。 因此,像素允许高精度的光学距离测量。 该像素结构的另一可能应用是荧光寿命成像显微镜(FLIM),其中必须抑制用于触发荧光的短激光脉冲。
    • 10. 发明申请
    • VERFAHREN ZUM HERUNTERFAHREN EINER WEBMASCHINE
    • 方法关机织机
    • WO2009033447A1
    • 2009-03-19
    • PCT/DE2008/001397
    • 2008-08-23
    • LINDAUER DORNIER GESELLSCHAFT MBHKRUMM, ValentinLAUKAMP, ThomasMETZLER, MichaelLEHMANN, Michael
    • KRUMM, ValentinLAUKAMP, ThomasMETZLER, MichaelLEHMANN, Michael
    • D03D51/08
    • D03D51/08D03C1/146
    • Bei einer Webmaschine werden die Fachbildemaschine durch einen Nebenmotor und das Webblatt durch den Hauptmotor der Webmaschine getrennt angetrieben. Wenn im Zeitpunkt 1.4 ein Stoppsignal gegeben wird, werden der Hauptmotor (Drehzahlverlauf 1.1) und die Fachbildemaschine (Drehzahlverlauf 1.2) getrennt heruntergefahren. Der Hauptmotor kommt im Zeitpunkt 1.5 und die Fachbildemaschine im Zeitpunkt 1.7 zum Stillstand. Wenn dabei vor Auftreten des Stoppsignals im Zeitpunkt 1.3 noch ein Schussfaden eingetragen worden ist, wird das Webfach N-1 geschlossen und das folgende Webfach N derart gesteuert, dass sich die Fachbildemittel bei Stillstand der Fachbildemaschine im Zeitpunkt 1.7 in der Fachgleichstellung befinden. Hierbei muss die Fachbildemaschine schon im Zeitpunkt 1.6 einen entsprechenden Steuerbefehl erhalten. Im Falle eines Schussfadenbruches wird die Fachbildemaschine derart gesteuert, dass beim Auslauf und/oder Stillstand der Fachbildemaschine das Webfach offen ist und der Schussbruch entfernt wird.
    • 在织机中,脱落机是由一个辅助马达和由织机的主马达分离的织造筘驱动。 当停止信号是在1.4时给出的,主电机(转速曲线1.1)和脱落机(1.2速度曲线),以分别关闭。 主电机是在时间1.5和脱落机,在1.7至停止的时间。 如果它已在1.3时的停止信号发生之前被登记又一个纬纱,梭口N-1关闭而下面的棚N被控制,使得脱落装置是在脱落机的停顿在本领域平等时间1.7。 在此,脱落的机器必须在时刻1.6已经接收相应的控制命令。 在纬纱的情况下破损脱落机进行控制,使得在所述脱落机器的出口和/或停止梭道是开放的,纬纱断裂被去除。