会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 5. 发明授权
    • Drum motor controller using microcomputer for intermittent slow VTR
    • 鼓电机控制器采用微型计算机间歇慢VTR
    • US06204986B1
    • 2001-03-20
    • US09117093
    • 1998-07-22
    • Yoshiki Hirose
    • Yoshiki Hirose
    • G11B2104
    • H04N5/783G11B15/026G11B15/125G11B15/1875G11B15/4671G11B15/4731
    • For intermittent slow activation, jitter is caused for reproduced image due to increase in the relative speed of a magnetic tape and a magnetic head. To solve this problem, a rotating speed of a drum motor 11 must also be increased. Then, a microcomputer 19 generates a control output PWM using as PWM data a value obtained by adding a prescribed value to a command value of a normal rotating speed, so as to perform correction control for activation. Thereby, correction to constant speed can always be achieved even when there is a difference between operating points of drum motor 11 due to the change in PWM data at the normal speed. Further, since jitter is caused for reproduced image due to the change in the relative speed of the magnetic tape and the magnetic head in braking a capstan motor 10, jitter is corrected by subtracting a prescribed value from the drum control PWM data at the normal rotating speed.
    • 对于间歇慢激活,由于磁带和磁头的相对速度的增加,对再现图像造成抖动。 为了解决这个问题,滚筒电动机11的旋转速度也必须增加。 然后,微型计算机19使用作为PWM数据的控制输出PWM,生成通过将规定值加到正常转速的指令值而获得的值,以进行激活的校正控制。 因此,即使由于正常速度下的PWM数据的变化,当鼓电动机11的工作点之间存在差异时,也可以始终实现恒定速度的校正。 此外,由于在主导电动机10制动时由于磁带和磁头的相对速度的变化引起的再现图像的抖动,所以通过从正常旋转的滚筒控制PWM数据减去规定值来校正抖动 速度。
    • 6. 发明授权
    • Apparatus for reproducing information from a tape-shaped recording
medium using calculated address information
    • 用于使用计算的地址信息从带状记录介质再现信息的装置
    • US5745317A
    • 1998-04-28
    • US541652
    • 1995-10-10
    • Takanobu SanoTakuji HimenoKatsumi IkedaHiroshi Takahata
    • Takanobu SanoTakuji HimenoKatsumi IkedaHiroshi Takahata
    • G11B5/027G11B15/12G11B15/18G11B15/467G11B15/473G11B15/52G11B20/10G11B20/12G11B27/00G11B27/10G11B27/30G11B5/584G11B15/46
    • G11B15/4673G11B15/4731G11B15/52G11B20/10G11B27/005G11B27/107G11B27/3027G11B15/125G11B15/1875G11B2220/90
    • A reproducing device for reproducing information from a tape-shaped recording medium, such as a magnetic tape, in which address information and data are recorded on the recording medium on a plurality of inclined tracks. The address information is composed of a track address and a block address. The reproducing device, which reads and reproduces data from the tape-shaped recording medium includes a reproducing unit, an address extracting unit, a memory, a driving unit and a controller. The reproducing unit reads out data from the tape-shaped reproducing medium for data reproduction. The reproducing unit has a rotary head configured for scanning a plurality of tracks of the tape-shaped recording medium for reading out data from the recording medium. The address extracting unit extracts the address information from data read out by the reproducing unit from one scan of the tape-shaped recording medium by the rotary head. The memory stores data read out from the reproducing unit. The data read out from the reproducing unit is written in the memory based upon the address information extracted by the address extraction unit. The driving unit runs the tape-shaped recording medium. The controller generates read-out addresses for reading out the data stored in the memory. The controller controls the driving unit based upon the address information which is extracted by the address extraction unit and which is associated with pre-set locations on the track of the tape-shaped recording medium.
    • 一种用于从诸如磁带的带状记录介质再现信息的再现装置,其中地址信息和数据被记录在多个倾斜轨道上的记录介质上。 地址信息由轨道地址和块地址组成。 从带状记录介质读取和再现数据的再现装置包括再现单元,地址提取单元,存储器,驱动单元和控制器。 再现单元从用于数据再现的带状再现介质读出数据。 再现单元具有旋转头,其被配置为扫描带状记录介质的多个轨道,用于从记录介质读出数据。 地址提取单元从通过旋转头从带状记录介质的一次扫描中提取由再现单元读出的数据的地址信息。 存储器存储从再现单元读出的数据。 基于由地址提取单元提取的地址信息,将从再现单元读出的数据写入存储器。 驱动单元运行带状记录介质。 控制器产生读出存储在存储器中的数据的读出地址。 控制器基于由地址提取单元提取并与带状记录介质的轨道上的预置位置相关联的地址信息来控制驱动单元。
    • 8. 发明授权
    • Control signal generating circuit for a magnetic recording and/or
reproducing apparatus
    • 用于磁记录和/或再现装置的控制信号产生电路
    • US4577243A
    • 1986-03-18
    • US601953
    • 1984-04-19
    • Yoshio Tokuyama
    • Yoshio Tokuyama
    • H04N5/7826G11B15/46G11B15/467G11B15/473G11B21/04
    • G11B15/4673G11B15/4731
    • A control signal generating circuit for a magnetic recording and/or reproducing apparatus comprises a monostable multivibrator for producing a pulse signal having a predetermined pulse width in response to a reference signal from a supplying circuit of the recording and/or reproducing apparatus, a flip-flop circuit responsive to the output pulse signal of the monostable multivibrator, for inverting an output thereof every time the pulse signal is supplied thereto, and an OR gate for producing a control signal responsive to the output pulse signal of the monostable multivibrator and the output of the flip-flop circuit, and for supplying the control signal to a control head, of the recording and/or reproducing apparatus, which records and/or reproduces the control signal on and/or from a magnetic tape.
    • 一种用于磁记录和/或再现装置的控制信号产生电路包括:单稳态多谐振荡器,用于响应于来自记录和/或再现装置的供电电路的参考信号产生具有预定脉冲宽度的脉冲信号; 响应于单稳态多谐振荡器的输出脉冲信号的触发电路,用于在每次提供脉冲信号时使其输出反相,以及OR门,用于响应于单稳态多谐振荡器的输出脉冲信号产生控制信号, 触发器电路,以及用于将控制信号提供给记录和/或再现装置的控制头,其在磁带上记录和/或再现控制信号。