会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 63. 发明授权
    • Inverter with protection function
    • 变频器具有保护功能
    • US07944652B2
    • 2011-05-17
    • US12094574
    • 2006-11-21
    • Kenichi Fukumoto
    • Kenichi Fukumoto
    • H05B41/16
    • H05B41/2828H05B41/2827H05B41/3927Y02B20/186
    • A pulse width modulator generates a PWM signal whose duty ratio is feedback-controlled so that a detection voltage according to a current across a secondary coil of a transformer is brought close to a reference voltage. A logic control unit performs a switching control of the current across the primary coil of the transformer, based on the PWM signal outputted from the pulse width modulator. A first protection circuit detects a circuit failure of an inverter and stops the switching control of the inverter when the circuit failure continues for a predetermined duration of error detection time. A second protection circuit monitors a feedback voltage corresponding to an output voltage of the inverter, and lowers the reference voltage sets the duration of error detection time short when the feedback voltage is lower than a predetermined threshold voltage.
    • 脉冲宽度调制器产生PWM信号,其占空比被反馈控制,使得根据变压器的次级线圈上的电流的检测电压接近参考电压。 逻辑控制单元基于从脉宽调制器输出的PWM信号,对变压器的初级线圈的电流进行切换控制。 第一保护电路检测逆变器的电路故障,并且当电路故障持续预定的错误检测时间的持续时间时,停止逆变器的切换控制。 第二保护电路监视与逆变器的输出电压相对应的反馈电压,并且当反馈电压低于预定阈值电压时,降低参考电压将误差检测时间的持续时间设置为短。
    • 65. 发明授权
    • Inverter using PWM method
    • 逆变器采用PWM方式
    • US07859197B2
    • 2010-12-28
    • US12093851
    • 2006-11-15
    • Kenichi Fukumoto
    • Kenichi Fukumoto
    • G05F1/00
    • H05B41/2806H02M7/53871Y02B20/22
    • The switching timing is flexibly set in an inverter.An H-bridge circuit is controlled based on a triangular wave signal and an error voltage. To control the circuit, a first high-side transistor and a second low-side transistor are turned on in a first period until the triangular wave signal reaches the error voltage. The first high-side transistor is turned on in a second period until the triangular wave signal reaches a peak edge. A second high-side transistor is turned on in a third period until the triangular wave signal reaches a bottom edge. A first low-side transistor and the second high-side transistor are turned on in a fourth period until the triangular wave signal reaches again the error voltage. The second high-side transistor is turned on in a fifth period until the triangular wave signal reaches again a peak edge. The first high-side transistor is turned on in a sixth period until the triangular wave signal reaches again a bottom edge.
    • 开关定时灵活地设置在逆变器中。 基于三角波信号和误差电压来控制H桥电路。 为了控制电路,第一高侧晶体管和第二低侧晶体管在第一周期中导通,直到三角波信号达到误差电压。 第一高侧晶体管在第二时段内导通,直到三角波信号达到峰值边缘。 在第三时段内第二高侧晶体管导通,直到三角波信号到达底边。 第一低侧晶体管和第二高侧晶体管在第四周期中导通,直到三角波信号再次达到误差电压。 第二高侧晶体管在第五周期中导通,直到三角波信号再次达到峰值边缘。 第一高侧晶体管在第六个周期中导通,直到三角波信号再次到达底部边缘。
    • 66. 发明申请
    • DRIVING APPARATUS AND METHOD FOR FLUORESCENT LAMP
    • 用于荧光灯的驱动装置和方法
    • US20100188614A1
    • 2010-07-29
    • US12665835
    • 2008-06-18
    • Kenichi FukumotoYasuhiro Yamada
    • Kenichi FukumotoYasuhiro Yamada
    • G02F1/1335H05B41/36
    • H05B41/2827
    • A driving apparatus includes an inverter to supply an AC voltage to Cold Cathode Fluorescent Lamps (CCFLs) to be driven. A first detection signal generation unit generates a first detection signal occurring by driving a first CCFL with the AC voltage. A second detection signal generation unit generates a second detection signal occurring by driving a second CCFL with the AC voltage. An abnormality detection circuit generates an abnormality detection signal corresponding to a difference between amplitudes of the first detection signal and the second detection signal. The driving apparatus compares the abnormality detection signal with a predetermined threshold value to execute a circuit protecting operation in accordance with a comparison result.
    • 驱动装置包括向要驱动的冷阴极荧光灯(CCFL)提供交流电压的逆变器。 第一检测信号生成单元通过用AC电压驱动第一CCFL产生第一检测信号。 第二检测信号生成单元通过用AC电压驱动第二CCFL产生第二检测信号。 异常检测电路产生与第一检测信号和第二检测信号的幅值之差对应的异常检测信号。 驱动装置将异常检测信号与预定阈值进行比较,以根据比较结果执行电路保护操作。
    • 68. 发明申请
    • INVERTER, ITS DRIVE METHOD, LIGHT EMITTING DEVICE AND LIQUID CRYSTAL TELEVISION USING THE SAME
    • 逆变器,其驱动方法,发光装置和使用其的液晶电视
    • US20090160357A1
    • 2009-06-25
    • US12093851
    • 2006-11-15
    • Kenichi Fukumoto
    • Kenichi Fukumoto
    • H05B41/36
    • H05B41/2806H02M7/53871Y02B20/22
    • The switching timing is flexibly set in an inverter.An H-bridge circuit is controlled based on a triangular wave signal and an error voltage. To control the circuit, a first high-side transistor and a second low-side transistor are turned on in a first period until the triangular wave signal reaches the error voltage. The first high-side transistor is turned on in a second period until the triangular wave signal reaches a peak edge. A second high-side transistor is turned on in a third period until the triangular wave signal reaches a bottom edge. A first low-side transistor and the second high-side transistor are turned on in a fourth period until the triangular wave signal reaches again the error voltage. The second high-side transistor is turned on in a fifth period until the triangular wave signal reaches again a peak edge. The first high-side transistor is turned on in a sixth period until the triangular wave signal reaches again a bottom edge.
    • 开关定时灵活地设置在逆变器中。 基于三角波信号和误差电压来控制H桥电路。 为了控制电路,第一高侧晶体管和第二低侧晶体管在第一周期中导通,直到三角波信号达到误差电压。 第一高侧晶体管在第二时段内导通,直到三角波信号达到峰值边缘。 在第三时段内第二高侧晶体管导通,直到三角波信号到达底边。 第一低侧晶体管和第二高侧晶体管在第四周期中导通,直到三角波信号再次达到误差电压。 第二高侧晶体管在第五周期中导通,直到三角波信号再次达到峰值边缘。 第一高侧晶体管在第六个周期中导通,直到三角波信号再次到达底部边缘。
    • 69. 发明申请
    • POWER SUPPLY DEVICE AND LIGHT-EMITTING DEVICE AND ELECTRONIC EQUIPMENT USING SUCH POWER SUPPLY DEVICE
    • 电源装置和发光装置以及使用这种电源装置的电子设备
    • US20090015177A1
    • 2009-01-15
    • US12162239
    • 2007-01-25
    • Kenichi Fukumoto
    • Kenichi Fukumoto
    • G05F1/00
    • H05B41/2827
    • In a power supply apparatus for supplying a power to a plurality of CCFLs, a plurality of transformers are provided for the respective CCFLs. Respective primary coils of the transformers are connected to each other in series so as to constitute one current path. One ends of respective secondary coils of the transformers are connected to the plurality of loads. An AC power supply unit generates an AC voltage and applies the AC voltage to the other ends of the secondary coils of the plurality of transformers. A capacitor is disposed on the current path formed with the primary coils of the transformers. A first fixed voltage is applied to one end of the current path, and a second fixed potential different from the first fixed voltage is applied to the other end of the current path.
    • 在向多个CCFL供电的供电装置中,为各个CCFL提供多个变压器。 变压器的各个初级线圈彼此串联连接,构成一个电流路径。 变压器的各个次级线圈的一端连接到多个负载。 AC电源单元产生AC电压,并将AC电压施加到多个变压器的次级线圈的另一端。 在与变压器的初级线圈形成的电流路径上设置电容器。 第一固定电压施加到电流路径的一端,并且与第一固定电压不同的第二固定电位施加到电流路径的另一端。
    • 70. 发明授权
    • Parallel operating system of DC-AC converters and controller IC therefor
    • DC-AC转换器和控制器IC的并行操作系统
    • US07471528B2
    • 2008-12-30
    • US11743598
    • 2007-05-02
    • Kenichi Fukumoto
    • Kenichi Fukumoto
    • H02J1/10
    • H02M1/36H02J7/0065H02M3/3376H02M2001/008H05B41/282H05B41/2828H05B41/3927Y02B20/186
    • A multiplicity of synchronized inverters for driving a multiplicity of loads such as CCFLs that require high ac voltages are arranged in close proximity of the respective loads and controlled in phase. A frequency determination capacitor and a frequency determination resistor are connected to one of the inverters to generate a triangular wave signal and a clock signal. The triangular wave signal and clock signal thus generated are supplied to other inverters to synchronize all the loads so that they can be controlled in phase. The resistance of the frequency determination resistor is set to a substantially small magnitude at the time of startup to increase the frequency of the triangular wave signal, thereby enabling quick startup of the loads.
    • 用于驱动多个负载的多个同步逆变器(例如需要高交流电压的CCFL)被布置成紧邻相应的负载并同相控制。 频率确定电容器和频率确定电阻器连接到一个逆变器以产生三角波信号和时钟信号。 这样产生的三角波信号和时钟信号被提供给其它逆变器以使所有负载同步,使得它们可以同相控制。 频率确定电阻器的电阻在启动时被设置为基本上小的幅度以增加三角波信号的频率,从而能够快速启动负载。