会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 1. 发明专利
    • GPS RECEIVER
    • JPH075239A
    • 1995-01-10
    • JP16970293
    • 1993-06-16
    • KODEN ELECTRONICS CO LTD
    • KATAYAMA SUSUMU
    • G01S19/20G01S19/40G01S5/14
    • PURPOSE:To correct the degrading of position accuracy at a low cost without special equipment depending on selective utilizing property by extracting the diurnal component of changes in position from a data observed at a known fixed point to be stored together with time for use as correction value. CONSTITUTION:Signals received by an antenna 1 and a receiver 2 are demodulated to perform a position calculation with a arithmetic section 3. A satellite radiowave is received at a fixed known point for more than 24 hour and a difference between the fixed point positional information and a measured position obtained by receiving radiowaves to compute is determined to be supplied to a signal processing section 5. A position error data (diurnal component of positional changes) extracted with a processing section 5 is stored into a memory section 6 together with date and time data. When a receiver is used in a moving object such as ship later for position measurement, in computation with the arithmetic section 3, a memory data of the memory section 6 is used to determined a position by correction. As a satellite appears at the same position as that on the preceding day at a cycle of about 23 hour and 56 minute, it is advanced by 4 minute per day thereby enabling the correction of the data by the memory data four minute later back from the preceding day.
    • 4. 发明专利
    • AFTER-STORAGE CORRELATION TYPE ULTRASONIC DETECTOR AND DISPLAY
    • JPS62240885A
    • 1987-10-21
    • JP2463887
    • 1987-02-06
    • KODEN ELECTRONICS CO LTD
    • KATAYAMA SUSUMUKOBAYASHI KENICHI
    • G01S7/62
    • PURPOSE:To enable a noise to be simply and easily removed by storing detection information before a correlation processing and correlating the adjacent read-out signals with each other among the read-out signals on the storage readout side. CONSTITUTION:Detection information is transferred to a main memory unit 22 via a terminal 22e and written in a RAM 75. The information read out of the RAM 75 is fed via a shift register 79 and the output of D1 of the register 79 and the output of D2 that is delayed from the output of D1 by one bit, that is, the two outputs D1 and D2 which are adjacent to each other in readout are given to a ROM 78. The ROM 78 is a code converter and the two pieces of information of D1 and D2 are converted to different pieces of information in the ROM 78. In the usual reflected and received signals of a fish finder in general, since no extreme difference is present between one piece of detection information and a subsequent piece of detection information, it scarcely occurs that the preceding detection information has no signal and the present detection information is received at a high level. On the other hand, since interference noises generated when the transmission signals of another fish finder are directly received are generally strong, when either of the two pieces D1 and D2 of information has no signal, the detected signal is forcibly invalidate so that the interference noises can be removed.
    • 6. 发明专利
    • SOUND WAVE DETECTOR
    • JPS60231191A
    • 1985-11-16
    • JP8880984
    • 1984-05-01
    • KODEN ELECTRONICS CO LTD
    • KATAYAMA SUSUMUKOBAYASHI KENICHI
    • G01S7/526G01S15/89G01S15/96
    • PURPOSE:To detect a reflected signal from the bottom of water accurately by clearing data in a memory section when the level of a reflected signal received is determined to be less than the level of the data of the memory section exceeding by a specified value. CONSTITUTION:When a transmission trigger pulse is generated, a gate 47 is opened and when the reflected signal received corresponding to the depth of the water bottom previously detected is obtained, the gate 37 is closed. When a comparator 36 determines that the received signal is smaller than the memory data of a memory section 37, the decision output 48 is given to the gate 47. Therefore, as the gate 47 is left open, until the reflected signal received corresponding to the reflected wave from the water bottom previously detected is received after the generation of the trigger pulse, an output 48 which was determined to be smaller on the side of the received signal from the comparator 36 passes by the gate 47 and the contents of the memory section 37 are cleared by the signal. Thus, the reflected signal from the water bottom can be detected accurately.
    • 9. 发明专利
    • Alarm device for water depth
    • 水深报警装置
    • JPS57120874A
    • 1982-07-28
    • JP588881
    • 1981-01-20
    • Koden Electronics Co Ltd
    • KATAYAMA SUSUMUKOBAYASHI KENICHIYAMADA TOSHIICHIMATSUSE TAKAYA
    • G01S15/96G01S15/93
    • G01S15/93
    • PURPOSE:To permit identification of the approach to an intended fishing field and shoals without viewing displayed video by comparing the magnitude of the numerical value of the variable range mark set depth and the numerical value of sea bottom depth, and giving an alarm. CONSTITUTION:The searching range of fish groups or the like is shifted with a shift switch 24 and the scale of depth is digitally displayed with a variable shift mark VRM signal generating circuit 25, so that the depth of the displayee video is read directly. The shift quantity information from the switch 24 and the VRM signal from the circuit 25 are inputted to a scale data processing circuit 26. On the other hand, the figure of the sea bottom depth measured actually with a sea bottom detecting circuit 79 is conducted to a magnitude comparator 57, and is compared with the VRM display depth figure from the circuit 26. Selection is accomplished with a switch 80 to output to an alarm 58 so as to give an alarm when the sea bottom is shallower than the VRM for the prevention of wrecking of ships and when the seam bottom is deeper than the VRM in case that a fishing boat is heading toward the fishing field.
    • 目的:通过比较可变范围标记集深度的数值和海底深度的数值,并给出报警,允许识别预期捕鱼场和浅滩的方法,而不查看显示的视频。 构成:利用移动开关24移动鱼群等的搜索范围,并且利用可变移动标记VRM信号生成电路25数字显示深度刻度,从而直接读取被显示视频的深度。 来自开关24的移位量信息和来自电路25的VRM信号被输入到比例数据处理电路26.另一方面,实际上用海底检测电路79测量的海底深度的图形被进行到 幅度比较器57,并且与电路26的VRM显示深度图进行比较。选择是通过开关80来实现的,以输出到报警器58,以便当海底比VRM浅,以防止 当船只正在向渔场前进时,船舶的沉没和VRM的深度比VRM更深。