会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 54. 发明申请
    • SCHEDULING BASED ON EFFECTIVE TARGET LOAD WITH INTERFERENCE CANCELLATION IN A WIRELESS COMMUNICATION SYSTEM
    • 基于无线通信系统干扰消除的有效目标负载调度
    • WO2009045923A1
    • 2009-04-09
    • PCT/US2008/077981
    • 2008-09-26
    • QUALCOMM INCORPORATEDZHANG, DanluMOHANTY, BibhuSAMBHWANI, Sharad Deepak
    • ZHANG, DanluMOHANTY, BibhuSAMBHWANI, Sharad Deepak
    • H04W16/00H04W16/14H04W72/08H04W16/10
    • H04W72/0486H04W72/082
    • Techniques for scheduling users for transmission on the uplink in a wireless communication system are described. A cell may perform interference cancellation for uplink transmissions and may observe lower effective noise and interference due to interference cancellation. The lower effective noise and interference may allow the cell to operate with a higher effective target load, which may support a higher overall throughput for the cell. In one design, an effective target load for a cell using interference cancellation may be determined, e.g., based on a target rise-over-thermal (RoT) for the cell and an interference cancellation efficiency factor. An available load for the cell may be determined based on the effective target load, which may be higher than a target load for the cell without interference cancellation. Users in the cell may then be scheduled for transmission on the uplink based on the available load.
    • 描述了在无线通信系统中调度用户在上行链路上传输的技术。 小区可以执行上行链路传输的干扰消除,并且可以观察到较低的有效噪声和由于干扰消除引起的干扰。 较低的有效噪声和干扰可以允许电池以更高的有效目标负载进行操作,这可以支持电池的更高的总吞吐量。 在一种设计中,可以例如基于小区的目标上升热(RoT)和干扰消除效率因子来确定使用干扰消除的小区的有效目标负载。 可以基于有效目标负载来确定小区的可用负载,该有效目标负载可能高于没有干扰消除的小区的目标负载。 然后可以基于可用负载来调度小区中的用户在上行链路上进行传输。
    • 60. 发明申请
    • FRAME EARLY TERMINATION OF UL TRANSMISSIONS ON DEDICATED CHANNEL
    • UL专用通道的框架早期终止
    • WO2013127053A1
    • 2013-09-06
    • PCT/CN2012/071665
    • 2012-02-27
    • QUALCOMM INCORPORATEDLIANG, JiyeHUANG, YinSAMBHWANI, Sharad DeepakAKKARAKARAN, Sony John
    • LIANG, JiyeHUANG, YinSAMBHWANI, Sharad DeepakAKKARAKARAN, Sony John
    • H04W28/00
    • H04L1/0053H04L1/0003H04L1/0009H04L1/0071H04L1/1829
    • A method for determining when transmissions of data and control information from a transceiver unit can be terminated prior to complete transmission of the data packets, in a system in which the receivers in the transceiver units attempt to decode the data packets prior to their complete receiption and send acknowledgment feedback about the success or failure of these decode attempts. The method consists of terminating the data transmission as well as the portion of the control transmission that is only required to enable decoding of the data transmission, as soon as the data transmission is acknowledged by its intended receiver, terminating the entire transmission (both data and control) as soon as both the following have occurred: the data transmission has already been terminated; the packet transmissions occuring during the same time interval that are intended for reception by the receiver within the transceiver unit have been received and an acknowledgment has been sent to indicate the reception.
    • 在收发器单元中的接收机尝试在其完全接收之前对数据分组进行解码的系统中,用于确定在收发器单元的数据和控制信息的传输何时可以在完成数据分组的传输之前终止的方法,以及 发送关于这些解码尝试的成功或失败的确认反馈。 该方法包括:一旦数据传输被其预期的接收机确认,终止整个传输(数据和数据的传输),终止数据传输以及控制传输的仅仅需要数据传输解码的部分 控制),一旦发生以下情况:数据传输已经终止; 已经接收到在收发器单元内由接收机预期接收的相同时间间隔内发生的分组传输,并且已经发送了确认以指示接收。