会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 2. 发明授权
    • Phase estimator with bias correction
    • 具有偏差校正的相位估计器
    • US07302016B1
    • 2007-11-27
    • US10640065
    • 2003-08-13
    • Michael RiceWilliam K. McIntire
    • Michael RiceWilliam K. McIntire
    • H03D3/22
    • H04L27/22
    • A method and serial detector for demodulating a phase-modulated signal are presented. In particular, a carrier phase estimator applies a phase estimate to an output of a matched serial filter. The filter output is matched to the first Laurent pulse of the received signal, and the phase estimate corrects for a phase bias introduced by using the first Laurent pulse. The method and detector are particularly valuable in Gaussian Minimum Shift Keying (GMSK) modulated systems and where then product of the bandwidth B and the bit rate Tb is less than about 0.3, and where a training sequence in a header of a burst system has a length L0 less than about 5000. Three estimates of phase offset are given, each taking the inner product of x and the conjugate transpose of either a or p; wherein x is a vector of data samples, a is a vector of pseudo symbols, and p is a vector of the data and ISI portions of the samples.
    • 提出了一种用于解调相位调制信号的方法和串行检测器。 具体地,载波相位估计器将相位估计应用于匹配的串行滤波器的输出。 滤波器输出与接收信号的第一Laurent脉冲相匹配,并且相位估计校正通过使用第一Laurent脉冲引入的相位偏差。 该方法和检测器在高斯最小偏移键控(GMSK)调制系统中特别有价值,其中带宽B和比特率T 的乘积小于约0.3,并且其中训练序列 突发系统的头部具有小于约5000的长度L 0 <0>。给出相位偏移的三个估计,每个估计为x的内积和a或p的共轭转置; 其中x是数据样本的向量,a是伪符号的向量,p是样本的数据和ISI部分的向量。
    • 9. 发明授权
    • Phase correction for a phase modulated signal with mutually interfering symbols
    • 具有相互干扰符号的相位调制信号的相位校正
    • US07263139B1
    • 2007-08-28
    • US10646101
    • 2003-08-22
    • Samuel C. KingstonOsama Sami HaddadinWilliam K. McIntire
    • Samuel C. KingstonOsama Sami HaddadinWilliam K. McIntire
    • H03D3/24H03D3/00H04L27/22
    • H04L27/2272H04L7/0054H04L7/0083H04L2027/0055
    • A circuit and method for correcting phase of a received phase modulated (PM) signal. The method uses k most recently received data bits, which alternate between in-phase I and quadrature Q bits, as an address for a lookup table 60. The lookup table outputs a phase figure 62 derived from a reconstructed waveform. When the most recent k bit is a Q bit, the complement 68 of the phase figure 62 is calculated to yield a phase correction. Otherwise, the phase figure is the phase correction, which is applied to adjust the phase of a delayed version of the received signal. The delayed, phase adjusted signal is then applied to correct the phase of a received signal. The circuit splits an input PM signal in parallel between a matched filter 54 and a delay block 76, 88. The matched filter output provides the input to a register 58 for storing the k data bits. The delay block holds the PM signal until it is input into a loop phase shifter 78 synchronously with the phase correction. The output of the loop phase filter is input, after filtering, to a primary phase shifter 52 that adjusts phase of a received PM signal.
    • 一种用于校正接收相位调制(PM)信号的相位的电路和方法。 该方法使用k个最近接收的数据位,其在同相I和正交Q位之间交替,作为查找表60的地址。 查找表输出从重构波形得出的相位图62。 当最近的k位是Q位时,相位图62的补码68被计算以产生相位校正。 否则,相位图是相位校正,其用于调整接收信号的延迟版本的相位。 然后施加延迟的相位调整信号以校正接收信号的相位。 电路将输入PM信号并入匹配滤波器54和延迟块76,88之间。 匹配滤波器输出将输入提供给寄存器58以存储k个数据位。 延迟块保持PM信号,直到其与相位校正同步地输入到环路移相器78中。 滤波后的环路相位滤波器的输出被输入到调整接收到的PM信号的相位的主移相器52。