会员体验
专利管家(专利管理)
工作空间(专利管理)
风险监控(情报监控)
数据分析(专利分析)
侵权分析(诉讼无效)
联系我们
交流群
官方交流:
QQ群: 891211   
微信请扫码    >>>
现在联系顾问~
热词
    • 5. 发明授权
    • Detecting the passing of magnetic articles using a transducer-signal
detector having a switchable dual-mode threshold
    • 使用具有可切换双模式阈值的换能器信号检测器检测磁性制品的通过
    • US6100680A
    • 2000-08-08
    • US851402
    • 1997-05-05
    • Ravi VigJay M. TowneP. Karl Scheller
    • Ravi VigJay M. TowneP. Karl Scheller
    • G01B7/00G01D3/02G01D5/14G01D5/244G01D5/245G01V3/08H03K17/95H03M1/30G01P3/488G01P3/489H03K5/08H03K5/153
    • G01D3/02G01D5/145G01D5/2448H03M1/303
    • A magnetic-field-to-voltage transducer includes a Hall element and a digitally gain-controlled Hall-voltage amplifier that produces an analog signal voltage Vsig having excursions of one polarity corresponding to the passing of magnetic articles. The gain of an AGC Vsig amplifier is only decreased in small sequential gain increments during an initial interval defined as that in which two excursions in Vsig have occurred, and the gain remains unchanged thereafter. Vsig is applied to the input of a peak-referenced-threshold signal detector that generates a binary output voltage, Vout, having transitions of one direction and the other direction corresponding respectively to the approach and retreat of the passing articles. The peak-referenced-threshold signal detector includes a dual-threshold-voltage comparator which is set to a large threshold at start-up. When just after start-up an excursion in the signal Vsig at the output of the amplifier exceeds a predetermined reference voltage, a small threshold obtains. Such an automatic threshold adjustment is made only in a brief initial period following start-up and not again until the proximity detector has been powered down and then started up again. This automatic dual-mode threshold feature prevents false detection due to "overshoots" that may be present in the transducer signal when the air gap is small, and leads to accurate detection over a wide range of air gaps between the transducer and the passing magnetic articles.
    • 磁场电压换能器包括霍尔元件和数字增益控制的霍尔电压放大器,其产生具有对应于磁性物品通过的一个极性的偏移的模拟信号电压Vsig。 AGC Vsig放大器的增益仅在定义为其中发生Vsig中的两个偏移的初始间隔期间以小的顺序增益增量减小,并且其后的增益保持不变。 Vsig被施加到产生二进制输出电压Vout的峰值参考阈值信号检测器的输入端,Vout分别具有一个方向的转变,另一个方向分别对应于通过的物品的进入和退出。 峰值参考阈值信号检测器包括在启动时被设置为大阈值的双阈值电压比较器。 当刚刚启动之后,放大器输出端的信号Vsig的偏移超过了预定的参考电压,得到一个小的阈值。 这样的自动阈值调整仅在启动之后的初始初始周期中进行,而不是再次直到接近检测器被断电然后再次启动。 这种自动双模阈值特征防止了当气隙小时可能存在于换能器信号中的“过冲”的错误检测,并且导致在换能器和通过的磁性物品之间的宽范围的气隙的精确检测 。
    • 7. 发明授权
    • Centering a signal within the dynamic range of a peak detecting proximity detector
    • 将信号置于峰值检测接近检测器的动态范围内
    • US06232768B1
    • 2001-05-15
    • US08852856
    • 1997-05-07
    • Kristann L. MoodyRavi VigP. Karl SchellerJay M. TowneTeri L. Tu
    • Kristann L. MoodyRavi VigP. Karl SchellerJay M. TowneTeri L. Tu
    • G01B730
    • G01D3/02G01D5/145G01D5/2448H03M1/303
    • A magnetic-field-to-voltage transducer includes a Hall element and a digitally gain-controlled Hall-voltage amplifier that produces an analog voltage Vsig having excursions of one polarity corresponding to the passing of magnetic articles. Vsig is applied to the input of a peak-referenced-threshold signal detector that generates a binary proximity-detector output voltage, Vout, having transitions of one direction upon approaches of gear teeth down to zero speed. A digitally gain-controlled amplifier is connected to the Hall element. A comparator circuit generates a binary signal Vbig (or Vtoobig) that changes from one to another binary level each time that Vsig exceeds a DC target voltage, VTG. The AGC circuit incrementally changes the transducer gain in the direction to bring the peaks in Vsig to just below the target value TTG. Reference voltages VP2 and VN2 are generated that are equal respectively to the most recent peak positive and negative going excursion in Vsig. DC off-set-limit voltages VA and VB are provided that are respectively above and below the center of the dynamic voltage range of the detector, and the entire signal Vsig at the output of the amplifier is biased in a negative direction when the median value, Vos, of Vsig is greater than VA and moving the entire signal Vsig in a less positive direction when Vos is less than VB to keep Vos within the range from VB to VA.
    • 磁场电压换能器包括霍尔元件和数字增益控制的霍尔电压放大器,其产生具有与磁性物品通过相对应的一个极性的偏移的模拟电压Vsig。 Vsig被施加到峰值参考阈值信号检测器的输入端,该检测器产生二进制接近检测器输出电压Vout,在齿轮齿接近零速度时具有一个方向的转变。 数字增益控制放大器连接到霍尔元件。 比较器电路每当Vsig超过DC目标电压VTG时产生从一个到另一个二进制电平的二进制信号Vbig(或Vtoobig)。 AGC电路逐渐改变传感器增益的方向,使Vsig中的峰值刚好低于目标值TTG。 产生参考电压VP2和VN2,其分别等于Vsig中最近的峰值正负偏移。 提供分别在检测器的动态电压范围的中心上方和下方的直流偏置电压VA和VB,并且当放大器的输出处的中值的偏移为放大器的输出端的整个信号Vsig时 ,Vsig的Vos大于VA,并且当Vos小于VB时将整个信号Vsig移动到较小的正方向,以将Vos保持在从VB到VA的范围内。
    • 9. 发明授权
    • Detection of passing magnetic articles while periodically adapting
detection thresholds to changing amplitudes of the magnetic field
    • 检测通过的磁性制品,同时周期性地调整检测阈值以改变磁场的振幅
    • US5650719A
    • 1997-07-22
    • US587407
    • 1996-01-17
    • Kristann L. MoodyRavi VigP. Karl SchellerJay M. TowneTeri L. Tu
    • Kristann L. MoodyRavi VigP. Karl SchellerJay M. TowneTeri L. Tu
    • G01B7/00G01D3/02G01D5/14G01D5/244G01D5/245G01V3/08H03K17/95H03M1/30G01P3/48G01P3/489
    • G01D5/24476G01D3/02G01D5/145G01D5/2448G01V3/081H03M1/303
    • A Hall transducer produces a signal Vsig. Threshold voltages V.sub.Pth and V.sub.Nth are generated at the beginning, t.sub.update, of each of a succession of update time intervals, of 64 pulses in Vsig, to be fixed percentages respectively of the peak to peak voltage in Vsig. A proximity-detector binary output voltage is high when Vsig exceeds threshold voltage V.sub.Pth and low when Vsig is below threshold voltage V.sub.Nth. Signals V.sub.Pold and V.sub.Nold, generated by first and second DACs, are equal to the first positive and negative peaks in Vsig after each time t.sub.update initiating the start of a successive interval. Signals V.sub.Pnew and V.sub.Nnew, simultaneously generated by third and fourth DACs, are equal to the greatest positive and negative peak voltages in Vsig during the interval ending at t.sub.update. Counters present their count to the first and second DACs that count pulses from a clock for tracking and holding +/- peaks in Vsig. After each time t.sub.update, a pulse in a signal Vupdt is generated if at time t.sub.update V.sub.Nnew lies outside the range. V.sub.Nold -v to V.sub.Nold +v of if V.sub.Nnew lies outside the range V.sub.Nold -v to V.sub.Nold +v, where v is an incremental DC bias voltage. Vupdt resets the counters so that during the succeeding update time interval the threshold voltages V.sub.Pth and V.sub.Nth have the fixed percentages of the updated threshold voltages V.sub.Pnew -V.sub.Nnew.
    • 霍尔传感器产生信号Vsig。 阈值电压VPth和VNth在Vsig中的64个脉冲的连续更新时间间隔的每一个的开始时产生,分别为Vsig中峰峰值电压的固定百分比。 当Vsig超过阈值电压VPth时,接近检测器二进制输出电压为高电平,当Vsig低于阈值电压VNth时,接近检测器二进制输出电压为高电平。 由第一和第二DAC产生的信号VPold和VNold等于每次启动连续间隔开始后的Vsig中的第一个正和负峰值。 由第三和第四DAC同时产生的信号VPnew和VNnew等于在tupdate结束的间隔期间的Vsig中最大的正和负峰值电压。 计数器将其计数器显示给第一和第二DAC,它们计数来自时钟的脉冲,用于跟踪Vsig中的+/-峰。 在每次tupdate之后,如果在tupdate VNnew处于该范围之外,则产生信号Vupdt中的脉冲。 如果VNnew位于VNold- + Z v到VNold ++ Z v的范围之外,则VNold- + Z v至VNold ++ Z v,其中+ Z v是增量DC偏置电压。 Vupdt复位计数器,使得在成功更新时间间隔期间,阈值电压VPth和VNth具有更新的阈值电压VPnew-VNnew的固定百分比。